|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
74ABT2244 Octal Buffer/Line Driver with 25 Series Resistors in the Outputs May 1992 Revised November 1999 74ABT2244 Octal Buffer/Line Driver with 25 Series Resistors in the Outputs General Description The ABT2244 is an octal buffer and line driver designed to drive the capacitive inputs of MOS memory drivers, address drivers, clock drivers, and bus-oriented transmitters/receivers. The 25 series resistors in the outputs reduce ringing and eliminate the need for external resistors. Features s Guaranteed latchup protection s High impedance glitch-free bus loading during entire power up and power down cycle s Nondestructive hot insertion capability Ordering Code: Order Number 74ABT2244CSC 74ABT2244CSJ 74ABT2244CMSA 74ABT2244CMTC 74ABT2244CPC Package Number M20B M20D MSA20 MTC20 N20A Package Description 20-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-013, 0.300" Wide Body 20-Lead Small Outline Package (SOP), EIAJ TYPE II, 5.3mm Wide 20-Lead Shrink Small Outline Package (SSOP), EIAJ TYPE II, 5.3mm Wide 20-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 4.4mm Wide 20-Lead Plastic Dual-In-Line Package (PDIP), JEDEC MS-001, 0.300" Wide Devices are also available in Tape and Reel. Specify by appending the suffix letter "X" to the ordering code. Connection Diagram Pin Descriptions Pin Names OE1, OE2 I0-I7 O0-O7 Description Output Enable Input (Active LOW) Inputs Outputs Schematic of Each Output Truth Table OE1 H L L I0-3 X H L O0-3 Z H L OE2 H L L I4-7 X H L O4-7 Z H L H = HIGH Voltage Level L = LOW Voltage Level X = Immaterial Z = High Impedance (c) 1999 Fairchild Semiconductor Corporation DS010991 www.fairchildsemi.com 74ABT2244 Absolute Maximum Ratings(Note 1) Storage Temperature Ambient Temperature under Bias Junction Temperature under Bias VCC Pin Potential to Ground Pin Input Voltage (Note 2) Input Current (Note 2) Voltage Applied to Any Output in the Disabled or Power-off State in the HIGH State Current Applied to Output in LOW State (Max) DC Latchup Source Current (Across Comm Operating Range) Over Voltage Latchup (I/O) -300 mA 10V twice the rated IOL (mA) -0.5V to 5.5V -0.5V to VCC -65C to +150C -55C to +125C -55C to +150C -0.5V to +7.0V -0.5V to +7.0V -30 mA to +5.0 mA Recommended Operating Conditions Free Air Ambient Temperature Supply Voltage Minimum Input Edge Rate (V/t) Data Input Enable Input 50 mV/ns 20 mV/ns -40C to +85C +4.5V to +5.5V Note 1: Absolute maximum ratings are values beyond which the device may be damaged or have its useful life impaired. Functional operation under these conditions is not implied. DC Electrical Characteristics Symbol VIH VIL VCD VOH VOL IIH IBVI IIL VID IOZH IOZL IOS ICEX IZZ ICCH ICCL ICCZ ICCT Parameter Input HIGH Voltage Input LOW Voltage Input Clamp Diode Voltage Output HIGH Output LOW Voltage Input HIGH Current Input HIGH Current Breakdown Test Input LOW Current Input Leakage Test 2.5 2.0 0.8 1 1 7 -1 -1 475 10 -10 -100 -275 50 100 50 30 50 2.5 2.5 50 Min 2.0 0.8 -1.2 Typ Max Units V V V V V V A A A V A A mA A A A mA A mA mA A mA/ 0.1 MHz Max Max Min Min Min Min Max Max Max 0.0 VCC Conditions Recognized HIGH Signal Recognized LOW Signal IIN = -18 mA IOH = -3 mA IOH = -32 mA IOL = 15 mA VIN = 2.7V (Note 4) VIN = VCC VIN = 7.0V VIN = 0.5V (Note 4) VIN = 0.0V IID = 1.9 A All Other Pins Grounded Output Leakage Current Output Leakage Current Output Short-Circuit Current Output HIGH Leakage Current Bus Drainage Test Power Supply Current Power Supply Current Power Supply Current 0 - 5.5V VOUT = 2.7V; OEn = 2.0V 0 - 5.5V VOUT = 0.5V; OEn = 2.0V Max Max 0.0 Max Max Max VOUT = 0.0V VOUT = VCC VOUT = 5.5V; All Others GND All Outputs HIGH All Outputs LOW OEn = V CC All Others at VCC or GND VI = VCC - 2.1V Enable Input VI = VCC - 2.1V Data Input VI = VCC - 2.1V All Others at VCCor GND Outputs OPEN OEn = GND (Note 3) One Bit Toggling, 50% Duty Cycle Additional ICC/Input Outputs Enabled Outputs 3-STATE Outputs 3-STATE ICCD Dynamic ICC (Note 4) No Load Note 2: Either voltage limit or current limit is sufficient to protect inputs. Note 3: For 8 bits toggling, ICCD < 0.8 mA/MHz. Note 4: Guaranteed, but not tested. www.fairchildsemi.com 2 74ABT2244 AC Electrical Characteristics (SOIC and SSOP Package) TA = +25C Symbol Parameter Min tPLH tPHL tPZH tPZL tPHZ tPLZ Propagation Delay Data to Outputs Output Enable Time Output Disable Time 1.0 1.0 1.5 2.1 1.7 1.7 VCC = +5V CL = 50 pF Typ 2.2 2.9 3.7 4.3 3.5 3.7 Max 3.9 4.4 6.0 7.0 5.8 5.8 1.0 1.0 1.5 2.1 1.7 1.7 TA = -40C to +85C VCC = 4.5V-5.5V CL = 50 pF Min Max 3.9 4.4 6.0 7.0 5.8 5.8 ns ns ns Units Capacitance Symbol CIN COUT (Note 5) Parameter Input Capacitance Output Capacitance Typ 5.0 9.0 Units pF pF VCC = 0V VCC = 5.0V Conditions TA = 25C Note 5: COUT is measured at frequency f = 1 MHz, per MIL-STD-883, Method 3012. 3 www.fairchildsemi.com 74ABT2244 AC Loading *Includes jig and probe capacitance FIGURE 1. Standard AC Test Load FIGURE 2. Test Input Signal Levels Amplitude 3.0V Rep. Rate 1 MHz tw 500 ns tr 2.5 ns tf 2.5 ns FIGURE 3. Test Input Signal Requirements AC Waveforms FIGURE 4. Propagation Delay Waveforms for Inverting and Non-Inverting Functions FIGURE 6. Propagation Delay, Pulse Width Waveforms FIGURE 5. 3-STATE Output HIGH and LOW Enable and Disable Times FIGURE 7. Setup Time, Hold Time and Recovery Time Waveforms www.fairchildsemi.com 4 74ABT2244 Physical Dimensions inches (millimeters) unless otherwise noted 20-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-013, 0.300" Wide Body Package Number M20B 5 www.fairchildsemi.com 74ABT2244 Physical Dimensions inches (millimeters) unless otherwise noted (Continued) 20-Lead Small Outline Package (SOP), EIAJ TYPE II, 5.3mm Wide Package Number M20D www.fairchildsemi.com 6 74ABT2244 Physical Dimensions inches (millimeters) unless otherwise noted (Continued) 20-Lead Shrink Small Outline Package (SSOP), EIAJ TYPE II, 5.3mm Wide Package Number MSA20 7 www.fairchildsemi.com 74ABT2244 Physical Dimensions inches (millimeters) unless otherwise noted (Continued) 20-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 4.4mm Wide Package Number MTC20 www.fairchildsemi.com 8 74ABT2244 Octal Buffer/Line Driver with 25 Series Resistors in the Outputs Physical Dimensions inches (millimeters) unless otherwise noted (Continued) 20-Lead Plastic Dual-In-Line Package (PDIP), JEDEC MS-001, 0.300" Wide Package Number N20A Fairchild does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and Fairchild reserves the right at any time without notice to change said circuitry and specifications. LIFE SUPPORT POLICY FAIRCHILD'S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user. 9 2. A critical component in any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. www.fairchildsemi.com www.fairchildsemi.com |
Price & Availability of 74ABT2244CMSA |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |