![]() |
|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
RF2366 4 Typical Applications * CDMA PCS Bypass LNA * CDMA PCS Bypass Driver Amplifier * General Purpose Amplification * Commercial and Consumer Systems 3V LOW NOISE AMPLIFIER/ 3V PA DRIVER AMPLIFIER Product Description The RF2366 is a switchable low noise amplifier with a very high dynamic range designed for digital cellular applications. The device functions as an outstanding front end low noise amplifier. When used as an LNA, the bias current can be set externally. When used as a PA driver, the IC can operate directly from a single cell Li-ion battery and includes a power down feature that can be used to completely turn off the device. The IC is featured in a standard SOT 6-lead plastic package. 1.80 1.40 0.50 0.35 3.10 2.70 0.10 MAX. 4 GENERAL PURPOSE AMPLIFIERS TEXT * 1.90 3.00 2.60 1.30 1.00 0.90 0.70 9 1 All dimensions in mm. 0.25 0.10 0.37 MIN. *When Pin 1 is in upper left, text reads downward (as shown). Optimum Technology Matching(R) Applied Si BJT Si Bi-CMOS u Package Style: SOT 6-Lead GaAs HBT SiGe HBT GaAs MESFET Si CMOS Features * Low Noise and High Intercept Point * Adjustable Bias Current * Power Down Control VREF/PD 1 Logic Control 6 SELECT * Single 2.5V to 6.0V Power Supply * 1000MHz to 2500MHz Operation * Meets IS-98B Single-Tone and IMD GND1 2 5 GND2 RF IN 3 4 RF OUT Ordering Information RF2366 3V Low Noise Amplifier/ 3V PA Driver Amplifier) RF2366 PCBA-PCS Fully Assembled Evaluation Board (LNA) Functional Block Diagram RF Micro Devices, Inc. 7625 Thorndike Road Greensboro, NC 27409, USA Tel (336) 664 1233 Fax (336) 664 0454 http://www.rfmd.com Rev A6 010816 4-183 RF2366 Absolute Maximum Ratings Parameter Supply Voltage Input RF Level Operating Ambient Temperature Storage Temperature Rating -0.5 to +8.0 +10 -40 to +85 -40 to +150 Unit VDC dBm C C Caution! ESD sensitive device. RF Micro Devices believes the furnished information is correct and accurate at the time of this printing. However, RF Micro Devices reserves the right to make changes to its products without notice. RF Micro Devices does not assume responsibility for the use of the described product(s). Parameter Specification Min. Typ. Max. Unit Condition TAMB =25C, VCC =3.0V RF=1930MHz to 1990MHz 4 GENERAL PURPOSE AMPLIFIERS Overall PCS Low Noise Amplifier Frequency Range HIGH GAIN MODE Gain Noise Figure IIP3 Current Drain Input VSWR Output VSWR BYPASS MODE Gain IIP3 Input VSWR Output VSWR Current Drain 1930 to 1990 10 9 12.5 1.4 14 6.5 1.8:1 1.6:1 -2.5 18.5 1.8:1 1.8:1 0.85 1850 to 1910 12 1.6 4 -60 1.9:1 1.6:1 6.5 -3 17 2:1 1.5:1 0.85 3 0.8 1.8 10 MHz Gain Select<0.8V, VPD/VREF =3V 1.8 dB dB dBm mA Gain Select>1.8V, VPD/VREF =0V -4.0 dB dBm 3:1 2.5:1 mA RF=1850MHz to 1910MHz MHz Gain Select<0.8V, VPD/VREF =3V dB dB dBm dBc/30kHz PCS CDMA Driver Frequency HIGH GAIN MODE Gain Noise Figure Output Power ACPR1 Input VSWR Output VSWR Current Drain BYPASS MODE Gain IIP3 Input VSWR Output VSWR Current Drain POUT =+4dBm, +1.25MHz offset mA Gain Select>1.8V, VPD/VREF =0V dB dBm mA V V V A Power Supply Voltage (VCC) VSELECT Low VSELECT High Power Down High Gain mode. Select<0.8V, VPD/VREF =3V Low Gain mode. Select>1.8V, VPD/VREF =0V Gain Select<0.8V, VPD/VREF =0V, VCC =0V 4-184 Rev A6 010816 RF2366 Bypass Possibility Gain Select >1.8V >1.8V VPD/VREF 0V 3V VCC 3V 3V Current 0.85mA 2mA Comments Recommended Bypass Mode Alternative Bypass Mode 4 GENERAL PURPOSE AMPLIFIERS Rev A6 010816 4-185 RF2366 Pin 1 Function VREF/PD Description For low noise amplifier applications, this pin is used to control the bias current. An external resistor can be used to set the bias current for any VPD voltage. Interface Schematic VREF/PD 2 3 GND1 RF IN Ground connection. For best performance, keep traces physically short and connect immediately to ground plane. RF input pin. 4 GENERAL PURPOSE AMPLIFIERS To Bias Circuit RF OUT RF IN 4 RF OUT 5 GND2 Amplifier output pin. This pin is an open-collector output. It must be biased to VCC through a choke or matching inductor. This pin is typically matched to 50 with a shunt bias/matching inductor and series blocking/matching capacitor. Refer to application schematics. LNA emittance inductance. Total inductance is comprised of package+bondwire+stripline (L1) on PCB. 6 SELECT This pin selects high gain and bypass. Select < 0.8V, high gain. Select > 1.8V, low gain. 4-186 Rev A6 010816 RF2366 Application Schematic PCS Low Noise Amplifier ~1950MHz C1 0.1F 1 C2 0.1F 2 50 strip C6 33 nF 3 4 R2 8.2 k L2 3.3 nH VCC C5 10 nF C4 100 pF Logic Control R1 1.3 k VREF/PD 6 L1 Minimum Length Stripline SELECT 5 C3 1.5 pF 50 strip J1 RF IN J2 RF OUT 4 GENERAL PURPOSE AMPLIFIERS Application Schematic PCS Driver Amplifier ~1880MHz C1 0.1F 1 C2 0.1F 2 50 strip C6 33 nF 3 4 R2 8.2 k L2 3.3 nH VCC C5 10 nF C4 100 pF Logic Control R1 1.3 k VREF/PD 6 L1 Minimum Length Stripline SELECT 5 C3 1.5 pF 50 strip J1 RF IN J2 RF OUT Rev A6 010816 4-187 RF2366 Evaluation Board Schematic - PCS LNA P1 P1-1 1 2 P1-3 3 CON3 VCC GND NC P2-3 P2-1 P2 1 2 3 CON3 C1 0.1F 1 C2 0.1F 2 50 strip C6 33 nF 3 4 R2 8.2 k 2366400A VREF GND SELECT R1 1.3 k 4 GENERAL PURPOSE AMPLIFIERS VREF Logic Control 6 L1 Minimum Length Stripline SELECT 5 C3 1.5 pF L2 3.3 nH VCC C5 10 nF C4 100 pF 50 strip J1 RF IN J2 RF OUT 4-188 Rev A6 010816 RF2366 Evaluation Board Layout - PCS Board Size 1.0" x 1.0" Board Thickness 0.031", Board Material FR-4 Assembly Top Back 4 GENERAL PURPOSE AMPLIFIERS Rev A6 010816 4-189 RF2366 12.9 12.9 12.8 12.8 High Gain Mode Gain versus VCC, PCS LNA Gain, -30 Gain, 25 Gain, 85 2.0 1.8 1.6 1.4 1.2 High Gain Mode NF versus VCC, PCS LNA Gain (dB) 12.7 12.7 12.6 NF (dB) 1.0 0.8 0.6 NF, -30 NF, 25 NF, 85 0.4 0.2 0.0 4 GENERAL PURPOSE AMPLIFIERS 12.6 12.5 12.5 2.5 2.7 2.9 3.1 3.3 3.5 2.5 2.7 2.9 3.1 3.3 3.5 VCC (V) VCC (V) 16.0 High Gain Mode IIP3 versus VCC, PCS LNA 11.0 10.0 IIP3, -30 IIP3, 25 IIP3, 85 9.0 8.0 7.0 6.0 5.0 4.0 3.0 2.0 High Gain Mode Total Current versus VCC, PCS LNA 15.5 15.0 I, -30 I, 25 I, 85 14.5 14.0 13.5 13.0 12.5 12.0 2.5 2.7 2.9 3.1 3.3 3.5 Total Current (mA) IIP3 (dBm) 2.5 2.7 2.9 3.1 3.3 3.5 VCC (V) VCC (V) -1.4 Gain, -30 Gain, 25 -1.6 Gain, 85 BYP Mode Gain versus VCC, PCS LNA 23.0 22.0 21.0 IIP3, -30 IIP3, 25 IIP3, 85 BYP Mode IIP3 versus VCC, PCS LNA -1.8 20.0 -2.0 IIP3 (dBm) 2.5 2.7 2.9 3.1 3.3 3.5 Gain (dB) 19.0 18.0 17.0 -2.2 -2.4 16.0 -2.6 15.0 -2.8 14.0 2.5 2.7 2.9 3.1 3.3 3.5 VCC (V) VCC (V) 4-190 Rev A6 010816 RF2366 12.20 High Gain Mode Gain versus VCC, PCS Driver 2.5 High Gain Mode NF versus VCC, PCS Driver 12.00 2.0 11.80 Gain (dB) 1.5 11.60 Gain, -30 11.40 Gain, 25 Gain, 85 0.5 11.20 NF (dB) 1.0 NF, -30 NF, 25 NF, 85 4 3.5 11.00 2.5 2.7 2.9 3.1 3.3 3.5 0.0 2.5 2.7 2.9 3.1 3.3 VCC (V) VCC (V) -2.5 Gain, -30 Gain, 25 Gain, 85 BYP Mode Gain versus VCC, PCS Driver 22.0 IIP3, -30 20.0 IIP3, 25 IIP3, 85 BYP Mode IIP3 versus VCC, PCS Driver -2.6 -2.7 18.0 -2.8 -2.9 IIP3 (dBm) Gain (dB) 16.0 -3.0 14.0 -3.1 12.0 -3.2 -3.3 2.5 2.7 2.9 3.1 3.3 3.5 10.0 2.5 2.7 2.9 3.1 3.3 3.5 VCC (V) VCC (V) 12.20 High Gain Mode Gain versus VCC, PCS Driver 2.5 High Gain Mode NF versus VCC, PCS Driver 12.00 2.0 11.80 Gain (dB) 1.5 11.60 Gain, -30 11.40 Gain, 25 Gain, 85 0.5 11.20 NF (dB) 1.0 NF, -30 NF, 25 NF, 85 11.00 2.5 2.7 2.9 3.1 3.3 3.5 0.0 2.5 2.7 2.9 3.1 3.3 3.5 VCC (V) VCC (V) Rev A6 010816 4-191 GENERAL PURPOSE AMPLIFIERS RF2366 -2.5 Gain, -30 Gain, 25 Gain, 85 BYP Mode Gain versus VCC, PCS Driver 22.0 IIP3, -30 20.0 IIP3, 25 IIP3, 85 BYP Mode IIP3 versus VCC, PCS Driver -2.6 -2.7 18.0 -2.8 -2.9 IIP3 (dBm) 2.5 2.7 2.9 3.1 3.3 3.5 Gain (dB) 16.0 -3.0 14.0 4 GENERAL PURPOSE AMPLIFIERS -3.1 12.0 -3.2 -3.3 10.0 2.5 2.7 2.9 3.1 3.3 3.5 VCC (V) VCC (V) 4-192 Rev A6 010816 |
Price & Availability of RF2366PCBA-PCS
![]() |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |