|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
NON-ISOLATED DC/DC CONVERTERS 3.0V-5.5V Input 0.8V-3.3V/12A Output X7AH-12F1A0 * * * * * Non-Isolated High Efficiency Fixed Frequency PRELIMINARY * * * * * OCP/SCP Input Under Voltage Lockout Remote On/Off Remote Sense (SMD module) Trim Function Excellent Thermal Performance Low Cost Description The Bel X7AH-12F1A0 is part of the low cost non-isolated dc to dc converter series. This converter is available in a range of output voltages from 0.9V to 3.3V. It is packaged in a compact, overmolded package rated at 12A. The output is closely regulated and the efficiency of 3.3V output module is typically 93% at full load. Typical features include remote on/off, input under voltage lockout, over current protection and short circuit protection. Part Selection Output Voltage 0.8V-3.3V Input Voltage 3.0V - 5.5V Max. Output Current 12A Max. Output Power 39.6W Typical Efficiency 93% Part Number Surface Mount S7AH-12F1A0 Part Number Vertical Mount V7AH-12F1A0 Absolute Maximum Ratings Parameter Input Voltage (continuous) Output Enable Terminal Voltage Ambient Temperature Storage Temperature Min -0.3V -0.3V -40C -55C Typ Max 6V 7V 85C 125C Notes Input Specifications Parameter Input Voltage 1 Input Current (no load) Input Current (full load) VO=3.3V VO=2.5V VO=1.8V VO=1.5V VO=1.2V VO=1.0V VO=0.9V Remote Off Input Current Input Reflected Ripple Current (pk-pk) Input Reflected Ripple Current (RMS) I2t Inrush Current Transient Turn on Voltage Threshold Turn off Voltage Threshold Min 3V Typ 120mA 2mA 100mA 35mA 0.09A2s 2.1V 2V Max 5.5V 200mA 11A 10.5A 9.0A 8.1A 6.5A 5.2A 3.2A 5mA 150mA 60mA 0.2A2s 2.4V With simulated source impedance of 500nH, 5Hz to 20MHz; use a 270uF/16V cap with ESR=0.0018 ohm max at 100KHz Notes Note: 1. The input voltage range of 3.3V output module is 4.5V-5.5V and that of 2.5V module is 3.6V-5.5V. Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 * Tel 201-432-0463 * Fax 201-432-9542 * www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 3.0V-5.5V Input 0.8V-3.3V/12A Output Output Specifications Parameter Output Voltage Set Point Line Regulation Load Regulation Regulation Over Temperature (-40C to +85C) Output Current Current Limit Threshold Short Circuit Surge Transient Ripple and Noise (RMS) Ripple and Noise (pk-pk) Turn on Time Overshoot at Turn on Output Capacitance Transient Response Overshoot 50% ~ 100% Max Load Settling Time 100% ~ 50% Max Load Overshoot Settling Time Min -2%Vo,set 0A 20A 330uF Typ 0.3A2s 12mV 50mV 5mS 0% 110mV 40uS 110mV 40uS Max 2%Vo,set 10mV 15mV 15mV 12A 30A 0.6A2s 21mV 100mV 10mS 3% 4800uF 150mV 80uS 150mV 80uS Notes Vin=5V, Io= 50% load Test conditions: 0-20MHz BW; 1uF ceramic capacitor and 330uF tantalum capacitor at the output. All Test conditions: di/dt=0.5A/us, Vin=5V, with 330uF external load capacitance. Notes: 1. All specifications are typical at 5V input, full load at 25C unless otherwise stated. 2. The input voltage range of 3.3V output module is 4.5V-5.5V and that of 2.5V module is 3.6V-5.5V. General Specifications Parameter Efficiency VO=3.3V VO=2.5V VO=1.8V VO=1.5V VO=1.2V VO=1.0V VO=0.9V Efficiency VO=1.8V VO=1.5V VO=1.2V VO=1.0V VO=0.9V Switching Frequency Output Trim Range Remote Sense Compensation MTBF Dimensions (surface mount) Inches (L x W x H) Millimeters (L x W x H) Dimensions (vertical) Inches (L x W x H) Millimeters (L x W x H) Weight 85% 81% 79% 78% 76% 250KHz 90%VO 88% 84% 82% 81% 79% 300KHz TBD 0.78 x 0.70 x 0.32 19.81 x 17.78 x 8.128 0.70 x 0.308 x 0.65 17.78 x 7.82 x 16.51 5.1g 350KHz 110%VO 0.2V Vin=3.3V, full load 90% 86% 84% 81% 79% 77% 75% 93% 89% 87% 84% 82% 80% 78% Min Typ Max Notes Vin=5V, full load SMD module Calculated Per Bell Core TR-332 (IO = 9.6A; Ta = 25C) - - Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 * Tel 201-432-0463 * Fax 201-432-9542 * www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 3.0V-5.5V Input 0.8V-3.3V/12A Output Control Specifications Parameter Remote On/Off Signal Low (Unit Off) Signal High (Unit On) Min -0.3V 2.4V Typ Max 0.8V Vin,max Notes Remote on/off pin open, unit on. Output Trim Equations Equations for calculating the trim resistor (in k) given the desired adjusted voltage (Vadj) and the nominal output voltage of the converter (Vnom) are shown below. The Trim Down resistor should be connected between the Trim pin and Vout. The Trim Up resistor should be connected between the Trim pin and Ground. Only one of the resistors should be used for any given application. RTrimDown = RTrimUp = 2.0 - 10.187 0.9 - Vadj Trim_do 7.0 - 0.187 Vadj - 0.9 Trim_up Thermal Derating Curves S7AH-12F330 V7AH-12F330 S7AH-12F250 V7AH-12F250 Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 * Tel 201-432-0463 * Fax 201-432-9542 * www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 3.0V-5.5V Input 0.8V-3.3V/12A Output Thermal Derating Curves (continued) S7AH-12F180 V7AH-12F180 S7AH-12F150 V7AH-12F150 S7AH-12F120 V7AH-12F120 S7AH-12F100 V7AH-12F100 Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 * Tel 201-432-0463 * Fax 201-432-9542 * www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 3.0V-5.5V Input 0.8V-3.3V/12A Output Efficiency Data 100.00% 95.00% 95.00% 90.00% 90.00% 4.5V 85.00% 5.0V 5.5V 80.00% 85.00% 3.6V 4.5V 5.5V 80.00% 75.00% 75.00% 70.00% 1 2 3 4 5 6 7 8 9 10 11 12 70.00% 1 2 3 4 5 6 7 8 9 10 11 12 X7AH-12F330 95.00% X7AH-12F250 90.00% 90.00% 85.00% 3V 3.3V 5V 85.00% 3V 3.3V 80.00% 5V 5.5V 80.00% 5.5V 75.00% 75.00% 70.00% 1 2 3 4 5 6 7 8 9 10 11 12 70.00% 1 2 3 4 5 6 7 8 9 10 11 12 X7AH-12F180 X7AH-12F150 90.00% 90.00% 85.00% 3V 3.3V 80.00% 5V 5.5V 85.00% 3V 3.3V 80.00% 5V 5.5V 75.00% 75.00% 70.00% 1 2 3 4 5 6 7 8 9 10 11 12 70.00% 1 2 3 4 5 6 7 8 9 10 11 12 X7AH-12F120 X7AH-12F100 Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 * Tel 201-432-0463 * Fax 201-432-9542 * www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 3.0V-5.5V Input 0.8V-3.3V/12A Output bel Pin Connections Pin 1 2 3 4 5 6 7 Function Remote On/Off (option) Vin Ground Vout Trim (option) Remote Sense (option) N/A bel Pin Connections Pin Function Remote On/Off (option) Vin Ground Vout Trim (option) bel 1 2 3 4 5 (c)2004 Bel Fuse Inc. Specifications subject to change without notice. 090204 CORPORATE Bel Fuse Inc. 206 Van Vorst Street Jersey City, NJ 07302 Tel 201-432-0463 Fax 201-432-9542 www.belfuse.com FAR EAST Bel Fuse Ltd. 8F/ 8 Luk Hop Street San Po Kong Kowloon, Hong Kong Tel 852-2328-5515 Fax 852-2352-3706 www.belfuse.com EUROPE Bel Fuse Europe Ltd. Preston Technology Management Centre Marsh Lane, Suite G7, Preston Lancashire, PR1 8UD, U.K. Tel 44-1772-556601 Fax 44-1772-888366 www.belfuse.com |
Price & Availability of X7AH-12F1A0 |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |