 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| High Performance Optical Component Solutions DATA S H E E T PP - 10G 10Gb/s PIN Preamp Receiver Features Low capacitance high speed InGaAs PIN detector. GaAs HBT preamp IC chip. Single polarity power supply. 11GHz bandwidth. Wide dynamic range. Hermetically sealed. Bellcore TR-NWT-000468 compliant. Applications Long and short reach SONET/SDH systems Optically preamplified receivers Datacom systems up to 12.5 Gb/s Description The PP-10G module consists of a low capacitance photodetector and a low noise GaAs transimpedance amplifier in an hermetic package with a connectorized single-mode fibre pigtail and a 50 SMA electrical output. RT -A 1 2 3 4 5 PP - 10G Characteristics Over entire temperature range, at end-of-Life General NRZ data rate Operating case temperature Physical dimensions SM fibre pigtail connector options 0 30 x 19 x 13.6 Standard SC-PC, Custom ST-PC, FC-PC Min Typ 10 70 Max Unit Gb/s 0 C mm Performance Module PIN bias voltage Positive supply Power dissipation PIN responsivity (1) PIN responsivity (5) Responsivity variation with temperature 00C to 700C Dark current (250C) Optical connector loss Sensitivity (2) Optical saturation power (BER< 10 ) Average input equivalent noise current density 30KHz - 10GHz High frequency -3dB corner (3) Transimpedance gain (3,4) Trans. gain variation with supply voltage and temperature (3) Output return loss (3) 100kHz - 8GHz -9 Symbol Vm Vcc Pd R R Min 9.5 7.5 Typ 11.5 8 1 0.88 0.83 5 Max 13.5 8.5 1.6 Unit V V W A/W A/W % Id 0.3 -18 Psat Ie 11 TZG 400 -15 10 500 0 -19 10 nA dB dBm dBm 16.5 pA/Hz GHz 650 +15 Ohms % dB Notes : 1. Excluding optical connector loss. Optical wavelength is in the 1300nm region and between 1525 - 1575nm. 2. For 10-10 BER, PRBS 223-1. NRZ @10Gb/s 3. Load impedance is 50 with a return loss > 20dB, up to 20GHz. 4. Excluding PIN responsivity factor and connector loss. 5. Excluding optical connector loss. Optical wavelength is in the range 1576 - 1610nm. PP - 10G 10Gb/s PIN Preamp Receiver PP - 10G Outline Drawing Dimensions in mm 19.0 11.0 9.0 2 x M2 3.0 3 x o3.5 6.0 o2.5 9.0 3.0 15.0 5.7 30.0 27.0 18.0 3.0 2.5 12.0 6.0 3.0 o6.35 12.0 10.0 13.5 35.0 5 HEATSHRINK 17.0 o0.4 9.0 11.0 Instructions for Use - PP-10G Pin 1 PIN Bias Pin 2, 4, 5 Ground SMA Electrical Output A DC voltage, between 9.5V and 13.5V, to reverse bias the PIN. This voltage should be present BEFORE the Positive Supply (pin 3) is applied to prevent the possibility of forward biasing the PIN (which will damage the device). Power down sequence is: pin 3, then pin 1. This pin should be decoupled externally to minimise conducted noise from the power rails. Ground all pins for optimum performance. Pin 3 Positive Supply 3.0 DC voltage between 7.5 and 8.5V provides power to the pre-amplifier IC. This pin should be decoupled externally to minimise conducted noise from the power rails. The source should be capable of supplying up to 150 mA. Device output is via the SMA connector and should be delivered into a 50 load. There is a DC offset of approximately 3V on this pin, so most applications will require that the output is AC coupled. PP - 10G 10Gb/s PIN Preamp Receiver PP - 10G Absolute Ratings Parameter Positive supply Operating temperature (1) Storage temperature (2) Maximum optical input (3) Maximum module PIN bias voltage Maximum peak module PIN current Minimum fibre bend radius Symbol Vcc Top Tstg Po Vm Im Ratings 9 0 to 70 -50 to 70 10 15 3 35 Units V 0 C C 0 dBm V mA mm Notes : 1. The operating temperature is defined as the temperature of the module case. 2. The storage temperature is defined as the ambient temperature. 3. The optical level that causes no damage to the module. Performance specified in this document is not guaranteed at this input power. Device Ordering Information PP - 10G (Standard connector SC/PC (C28B) Connector type FC/PC = C33 A Qualification Test Report QR1317B is also available for this device Nortel Networks Optical Components Ltd. Brixham Road Paignton Devon TQ4 7BE United Kingdom Tel: +44 1803 662106 Fax: +44 1803 662801 Email: opticalcomponents@nortelnetworks.com www.nortelnetworks.com/components/ PB0095 ISSUE 2 July 2000 Certificate No. FM 15040 All data in this document is subject to change in accordance with Nortel Networks Corporation policy of continual product improvement. No data in this document is intended to be used in connection with any contract except as may be first confirmed in writing by Nortel Networks Corporation. The publication of information in this document does not imply freedom from patent or other rights of Nortel Networks Corporation or others. (c) 2000 Nortel Networks. All rights reserved. (c) Nortel Networks, Nortel Networks Logo, the Globemark and Unified Networks are trademarks of Nortel Networks. Information in this document is subject to change without notice. Nortel Networks assumes no responsibility for errors that might appear in this document. Printed in England. Certificate No. EMS 35100 |
Price & Availability of PP-10G
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |