 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| (R) VN540 / VN540SP / VN540(011Y) / VN540(012Y) HIGH SIDE SMART POWER SOLID STATE RELAY TYPE VN540 VN540SP VN540(011Y) VN540(012Y) Vdemag RDS(on) IOUT VCC -55V 50m 2.8A 36 V OUTPUT CURRENT (CONTINUOUS): 2.8A s DIGITAL INPUT CLAMPED AT 32V s PROTECTION AGAINST: LOSS OF GROUND, SHORTED LOAD AND OVERTEMPERATURE s BUILT-IN CURRENT LIMITER s UNDER VOLTAGE SHUT DOWN s OPEN DRAIN DIAGNOSTIC OUTPUT s FAST DEMAGNETIZATION OF INDUCTIVE LOADS. s PENTAWATT(011Y) PENTAWATT(012Y) 10 1 PENTAWATT PowerSO-10 TM DESCRIPTION The VN540, VN540SP, VN540(011Y), VN540(012Y) is a monolithic device designed in STMicroelectronics VIPower technology, intended for driving resistive or inductive loads with one side connected to ground. Active current limitation avoids the system power supply dropping in case of shorted load. Built-in thermal shut down protects the chip from over temperature. The open drain diagnostic output indicates over temperature conditions. BLOCK DIAGRAM ORDER CODES PENTAWATT vertical VN540 PENTAWATT horizontal VN540(011Y) PENTAWATT straight VN540(012Y) PowerSO-10TM VN540SP VCC UNDERVOLTAGE INPUT STATUS CONTROL LOGIC DRIVER OUTPUT CURRENT LIMITER OVERTEMP NEGATIVE VCC PROTECTION GROUND October 1999 1/11 1 VN540 / VN540SP / VN540(011Y) / VN540(012Y) ABSOLUTE MAXIMUM RATING Symbol VCC -VCC IOUT IR IIN ISTAT VESD PTOT Tj TSTG EAS Parameter Power supply voltage Reverse supply voltage Maximum DC load current Reverse output current Input current Status pin current Electrostatic discharge (R=1.5k, C=100pF) Power dissipation at Tc=25C Junction operating temperature Storage temperature Single pulse avalanche energy Value 45 -4.0 Internally limited -10 +/- 10 +/- 10 2000 Internally limited Internally limited -55 to 150 500 Unit V V A A mA mA V W C C mJ CONNECTION DIAGRAM TOP VIEW GROUND INPUT STATUS N.C. N.C. 6 7 8 9 10 11 VCC 5 4 3 2 1 OUTPUT OUTPUT N.C. OUTPUT OUTPUT PowerSO-10TM PENTAWATT CURRENT AND VOLTAGE CONVENTIONS 2/11 1 VN540 / VN540SP / VN540(011Y) / VN540(012Y) THERMAL DATA Symbol Rthj-case Rthj-amb Parameter Thermal resistance junction-case Thermal resistance junction-ambient (MAX) (MAX) Value PowerSO-10 PENTAWATT 1.5 2.0 50 60 Unit C/W C/W ELECTRICAL CHARACTERISTICS (10V IS Supply current ILS ILGND VOL Vdemag Output leakage current Output current at turn-off Low state output voltage Output voltage at turn-off SWITCHING Symbol td(on) Parameter Turn-on delay on output current Rise time of output current Turn-off delay on output current Fall time of output current Turn-on current average slope Turn-off current average slope Test Conditions IOUT =2.8A; Resistive Load Input rise time <0.1s; VCC=24V; Tj=25C IOUT =2.8A; Resistive Load Input rise time <0.1s; VCC=24V; Tj=25C IOUT =2.8A; Resistive Load Input rise time <0.1s; VCC=24V; Tj=25C IOUT =2.8A; Resistive Load Input rise time <0.1s; VCC=24V; Tj=25C IOUT =2.8A IOUT =ILIM; 25C 60 s td(off) 60 s tf dI/dt(on) dI/dt(off) 25 0.5 2 2 4 s A/s A/s A/s A/s LOGIC INPUT Symbol VIL VIH VI(hyst) IIN VICL Parameter Input low level voltage Input high level voltage Input hysteresis voltage Input current Input clamp voltage (see note 1) VIN=30V VIN=2.0V IIN=1mA IIN=-1mA 25 32 36 -0.7 Test Conditions Min 3.5 0.5 300 Typ Max 2.0 Unit V V V A A V V 3/11 1 VN540 / VN540SP / VN540(011Y) / VN540(012Y) PROTECTIONS AND DIAGNOSTICS Symbol VSTAT VSCL (*) ISTAT VUSD ILIM tSC TTSD TR Parameter Status output voltage Status clamp voltage Leakage on diagnostic pin in high state Undervoltage shut-down DC short circuit current Delay time of current limiter Thermal shut-down temperature Thermal reset temperature Test Conditions ISTAT=5mA (Fault condition) ISTAT=1mA ISTAT=-1mA VSTAT=5V 5.0 2.8 Min Typ Max 1 32 36 0.7 10 8.0 8.0 100 150 135 170 155 Unit V V V A V A s oC oC VCC=24V, RLOAD<0.1 5.0 (*) Status determination > 100s after the switching edge. SWITCHING CHARACTERISTICS Note 1: The input voltage is internally clamped at 32V minimum, it is possible to connect the input pins to an higher voltage via an external resistor calculate to not exceed 10mA. Note 2: If INPUT pin is floating the corresponding channel will automatically switch off. If GND pin is disconnected, the channel will switch off provided VCC not exceed 36V. 4/11 2 VN540 / VN540SP / VN540(011Y) / VN540(012Y) THRUTH TABLE INPUT Normal operation Overtemperature Undervoltage Shorted load (Current limitation) L H L H L H L H OUTPUT L H L L L L L H STATUS H H H L H H H H Fig. 1: Peak Short Test Circuit +VCC 10k STATUS IN CONTROL UNIT RIN GND RL<10m OUTPUT GND 5/11 1 VN540 / VN540SP / VN540(011Y) / VN540(012Y) Figure 2: Waveforms Fig. 3: ILGND Test Configuration + VCC STATUS I/O1 GND OUT A 6/11 2 VN540 / VN540SP / VN540(011Y) / VN540(012Y) PowerSO-10TM MECHANICAL DATA DIM. A A1 B c D D1 E E1 E2 E3 E4 e F H h Q 0 1.25 13.80 0.50 1.70 8 mm. MIN. 3.35 0.00 0.40 0.35 9.40 7.40 9.30 7.20 7.20 6.10 5.90 1.27 1.35 14.40 0.049 0.543 0.002 0.067 TYP MAX. 3.65 0.10 0.60 0.55 9.60 7.60 9.50 7.40 7.60 6.35 6.10 MIN. 0.132 0.000 0.016 0.013 0.370 0.291 0.366 0.283 0.283 0.240 0.232 0.050 0.053 0.567 inch TYP. MAX. 0.144 0.004 0.024 0.022 0.378 0.300 0.374 0.291 300 0.250 0.240 B 0.10 A B 10 = = 6 = = H = E = = E2 E3 E1 = E4 = = A 1 5 = SEATING PLANE DETAIL "A" Q e 0.25 M B C D h = A F A1 = D1 = = SEATING PLANE = A1 L DETAIL "A" 7/11 1 VN540 / VN540SP / VN540(011Y) / VN540(012Y) PENTAWATT (IN-LINE) MECHANICAL DATA DIM. A C D D1 E F F1 G G1 H2 H3 L2 L3 L5 L6 L7 Diam. 10.05 23.05 25.3 2.6 15.1 6 3.65 23.4 25.65 2.4 1.2 0.35 0.8 1 3.2 6.6 3.4 6.8 mm. MIN. TYP MAX. 4.8 1.37 2.8 1.35 0.55 1.05 1.4 3.6 7 10.4 10.4 23.8 26.1 3 15.8 6.6 3.85 0.396 0.907 0.996 0.102 0.594 0.236 0.144 0.921 1.010 0.094 0.047 0.014 0.031 0.039 0.126 0.260 0.134 0.268 MIN. inch TYP. MAX. 0.189 0.054 0.110 0.053 0.022 0.041 0.055 0.142 0.276 0.409 0.409 0.937 1.028 0.118 0.622 0.260 0.152 8/11 1 VN540 / VN540SP / VN540(011Y) / VN540(012Y) PENTAWATT (HORIZONTAL) MECHANICAL DATA DIM. A C D D1 E F F1 G G1 H2 H3 L L1 L2 L3 L5 L6 L7 Diam. 10.05 14.2 5.7 14.6 3.5 2.6 15.1 6 3.65 2.4 1.2 0.35 0.8 1 3.2 6.6 3.4 6.8 mm. MIN. TYP MAX. 4.8 1.37 2.8 1.35 0.55 1.05 1.4 3.6 7 10.4 10.4 15 6.2 15.2 4.1 3 15.8 6.6 3.85 0.137 0.102 0.594 0.236 0.144 0.396 0.559 0.094 0.047 0.014 0.031 0.039 0.126 0.260 0.134 0.268 MIN. inch TYP. MAX. 0.189 0.054 0.110 0.053 0.022 0.041 0.055 0.142 0.276 0.409 0.409 0.590 0.244 0.598 0.161 0.118 0.622 0.260 0.152 9/11 1 VN540 / VN540SP / VN540(011Y) / VN540(012Y) PENTAWATT (VERTICAL) MECHANICAL DATA DIM. A C D D1 E F F1 G G1 H2 H3 L L1 L2 L3 L5 L6 L7 M M1 Diam. 3.65 2.6 15.1 6 4.5 4 3.85 0.144 10.05 17.85 15.75 21.4 22.5 3 15.8 6.6 0.102 0.594 0.236 0.177 0.157 0.152 2.4 1.2 0.35 0.8 1 3.2 6.6 3.4 6.8 mm. MIN. TYP MAX. 4.8 1.37 2.8 1.35 0.55 1.05 1.4 3.6 7 10.4 10.4 0.396 0.703 0.620 0.843 0.886 0.118 0.622 0.260 0.094 0.047 0.014 0.031 0.039 0.126 0.260 0.134 0.268 MIN. inch TYP. MAX. 0.189 0.054 0.110 0.053 0.022 0.041 0.055 0.142 0.276 0.409 0.409 10/11 1 VN540 / VN540SP / VN540(011Y) / VN540(012Y) Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may results from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics. The ST logo is a trademark of STMicroelectronics (c) 1999 STMicroelectronics - Printed in ITALY- All Rights Reserved. STMicroelectronics GROUP OF COMPANIES Australia - Brazil - Canada - China - France - Germany - Italy - Japan - Korea - Malaysia - Malta - Mexico - Morocco The Netherlands - Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A. http://www.st.com 11/11 1 |
Price & Availability of VN540-011Y
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |