high performance amplifier, 15 db gain 5 - 200 mhz am-/amc-134 north america: tel. (800) 366-2266, fax (800) 618-8883 asia/pacific: tel.+81-44-844-8296, fax +81-44-844-8298 europe: tel. +44 (1344) 869 595, fax+44 (1344) 300 020 specifications subject to change without notice. visit www.macom.com for additional data sheets and product information. v 3.0 features ? +49 dbm typical midband third order intercept ? +29 dbm typical midband 1 db compression ? 4.8 db typical midband noise figure description m/a-com?s AM-134 is a coupler feedback amplifier with high intercept and compression points. the use of coupler feedback minimizes noise figure and current in a high intercept amplifier. this amplifier is packaged in a flatpack with flanges. due to the metal flatpack the thermal rise minimized. the ground plane on the pc board should be configured to remove heat from under the package. AM-134 is ideally suited for use where a high intercept, high reliability amplifier is required. fp-8 ordering information part number package AM-134 pin amc-134 sma flatpack connectorized c-25 absolute maximum ratings 1 parameter absolute maximum max. input power +15 dbm v bias +17.0 v operating temperature -55c to +85c storage temperature -65c to +125c 1. operation of this device above any one of these parameters may cause permanent damange. pin configuration pin # function pin # function 1 rf out 6 rf in 2 gnd 1 7 gnd 2 3 gnd 8 rf out 4 gnd 9 gnd 5 vbias 10 gnd
high performance amplifier, 15 db gain, 5 - 200 mhz am-/amc-134 north america: tel. (800) 366-2266, fax (800) 618-8883 asia/pacific: tel.+81-44-844-8296, fax +81-44-844-8298 europe: tel. +44 (1344) 869 595, fax+44 (1344) 300 020 specifications subject to change without notice. visit www.macom.com for additional data sheets and product information. v 3.0 electrical specifications 2 t a = -55c to +85c case temperature parameter test conditions frequency units min typical max gain 50 mhz @ +25c 50 mhz db 14.0 14.6 15.2 frequency response ? 5 - 200 mhz db ? ? 0.5 gain variation with temperature ? 5 - 200 mhz db -1.0 ? +0.5 1 db compression output power 5 - 200 mhz dbm +23 ? ? noise figure ? 5 - 200 mhz db ? ? 7.0 reverse transmission ? 5 - 200 mhz db ? -21 -19 vswr ? 5 - 200 mhz ratio ? ? 2.5:1 output ip 2 two-tone inputs up to +10 dbm 5 - 200 mhz dbm +55 ? ? output ip 3 two-tone inputs up to +10 dbm 5 - 200 mhz 5 - 70 mhz dbm dbm +37 +42 ? ? ? ? vbias ? ? v 14.25 15 15.75 ibias 1.35w typical ? ma ? 90 110 typical performance 2. all specifications apply when operated at +15 vdc, with 50 ohms source and load impedance. 3. heat sinking: operation at case temperature above 95c is not recommended. heat sinking adequate to dissipate 1.35w must be p rovided in use. gain vs. frequency 13.0 14.0 15.0 16.0 3 5 10 20 50 100 200 300 frequency (mhz) gain (db) 85c 25c -55c intermodulation intercept 58 60 62 64 66 3 5 10 20 50 100 200 300 frequency (mhz) intercept (dbm)ip2 42 44 46 48 50 intercept (dbm) ip3 ip2 ip3 noise figue and 1 db compression 4.0 4.5 5.0 5.5 3 5 10 20 50 100 200 300 frequency (mhz) noise figure (db) 26 27 28 29 output power (dbm) noise figure output power vswr vs. frequency 1.00 1.25 1.50 1.75 2.00 3 5 10 20 50 100 200 300 frequency (mhz) vswr rf in rf out
|
