OCO1000-15 ocxo vectron international www.vectron.com 49-07268-801-281 fax 49-07268-801-0 tel germany d-74924 neckarbischofsheim landstrasse vectron international gmbh & co. kg modified 2007-10-09 index : 20 printed 2008-08-20 ? page 1 of 4 vectron international ? product specifications nominal frequency (f0) 20 mhz frequency stabilities parameter frequency stability operating temp. range vs. operating temp. range (df/f@25 c) -10 to 10 ppb 0 ... 70 c parameter value condition initial tolerance (df/f0) -500 to 500 ppb @vc = 2 v; 25 c vs. supply voltage change (df/f) -3 to 3 ppb static; 5 v 5 % vs. load change (df/f) -2 to 2 ppb static; load 5 % vs. aging / daily (df/f) < 1.5 ppb after 30 days ; @ 25 c vs. aging / month (df/f) < 40 ppb after 30 days ; @ 25 c vs. aging / year (df/f) < 100 ppb after 30 days ; @ 25 c vs. aging / 15 years (df/f) < 2 ppm after 30 days ; @ 25 c frequency tuning parameter value condition electrical frequency control (efc) (df/f0) -3 to -1.5 ppm ext. tuning voltage @ 0 v 1.5 to 3 ppm ext. tuning voltage @ 4 v linearity < 10 % ref.volt. output: 4v +/-5% rf output parameter value condition signal hcmos load 15 pf 5 % fan out 3 rise time < 5 ns @ 0.5 to 4.5 v fall time < 5 ns @ 4.5 to 0.5 v duty cycle 40 / 60 % @ 2.5 v v lo w x < 0.5 v v high x > 4.5 v supply voltage parameter value condition supply voltage (vs) 5 v 5 % current consumption steady state < 200 ma @ vsnom & 25 c current consumption during warm up < 500 ma @ vs additional parameters parameter value condition warm-up time < 5 min @ 25 c to final frequency a dditional information typ. phase noise: <-110dbc/hz at 10hz, <-145dbc/hz at 50khz processing & packing handling&processing note additional environmental conditions tensile strength of leads din iec 68-2-21, test ua 1 flexibility of leads din iec 68-2-21 test ub sealing test a staubdicht (dust-dense) solderability din iec 68-2-20 test ta solvent resistance en 60068-2-45, test xa
OCO1000-15 ocxo vectron international www.vectron.com 49-07268-801-281 fax 49-07268-801-0 tel germany d-74924 neckarbischofsheim landstrasse vectron international gmbh & co. kg modified 2007-10-09 index : 20 printed 2008-08-20 ? page 2 of 4 vectron international ? product specifications absolute maximum ratings parameter min typ max units condition operable temperature range -20 80 c storage temperature range -40 90 c enclosure type g185 height 11.3 mm all units in mm pin connections pin 1: vc (control voltage) pin 2: uref (ref. voltage output) pin 3: vs (supply voltage) pin 4: hf-output pin 5-6: n.c. pin 7: gnd(case) marking OCO1000-15 20,000 mhz ser.nr ayyww * * pin-1 marking dot
OCO1000-15 ocxo vectron international www.vectron.com 49-07268-801-281 fax 49-07268-801-0 tel germany d-74924 neckarbischofsheim landstrasse vectron international gmbh & co. kg modified 2007-10-09 index : 20 printed 2008-08-20 ? page 3 of 4 vectron international ? product specifications reflow profile profile feature pb-free assembly/sn-pb assembly average ramp-up rate (tl to tp) 3c/second max. preheat -temperature min (tsmin) 150c -temperature min (tsmax) 200c -time (min to max) (ts) 60-180 seconds tsmax to tl - ramp-up rate 3c/second max. time maintainted above - temperature (tl) 217c - time (tl) 60-150 seconds peak temperature (tp) max 260c time within 5c of actual peak temperature (tp) 20-40 seconds ramp-down rate 6c/second max. time 25c to peak temperature 8 minutes max. note: all temperatures refer to topside of the package, measured on the package body surface. a dditional information this smd oscillator has been designed for pick and place reflow soldering. smd oscillators must be on the top side of the pcb during the reflow process.
OCO1000-15 ocxo vectron international www.vectron.com 49-07268-801-281 fax 49-07268-801-0 tel germany d-74924 neckarbischofsheim landstrasse vectron international gmbh & co. kg modified 2007-10-09 index : 20 printed 2008-08-20 ? page 4 of 4 vectron international ? product specifications standard shipping method tape width w [mm] quantity per meter quantity per reel p [mm] a [mm] b [mm] k [mm] 44 35.7 175 28 22.5 25.9 12.8 notes: unless otherwise stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency control voltage, load, temperature (25c). subject to technical modification.
|