features n 20 db high gain n 60 ma maximum low power description m/a - com?s am - 184 is a feedback amplifier with high intercept and c ompression points. this amplifier is packaged in a to - 8 package. due to the internal power dissipation the thermal rise shoul d be minimized. the ground plane on the pc board should be configured to remove heat from under the package. am - 184 is ideall y suited for use where a high intercept, high reliability amplifier is required. cascadable thin film amplifier, 20 db gain, 10 - 2000 mhz am - /amc - 184 to - 8 - 1 c - 32 absolute maximum ratings 1 1. operation of this device above any one of these parameters may cause permanent damage. parameter absolute maximum max input power +13 dbm vbias +15.75 v operating temperature - 55c to +85c storage temperature - 65c to +125c v 3.00
cascadable thin film amplifier, 20 db gain, 10 - 2000 mhz am - /amc - 184 specifications subject to change without notice. n north america: tel. (800) 366 - 2266 n asia/pacific: tel.+ 81 - 44 - 844 - 8296 , fax + 81 - 44 - 844 - 8298 n europe: tel. +44 (1344) 869 595, fax+44 (1344) 300 020 visit www.macom.com for additional data sheets and product information. v 3.00 2 electrical specifications 2,3 t a = - 55c to +85c case temperature parameter test conditions frequency units min. typ. max. gain @ +25 c 1000 mhz db 19.0 20.0 21.0 frequency response ? 10 - 2000 mhz db ? ? 1.5 gain variation with temperature ? 10 - 2000 mhz db ? ? 1.5 1 db compression output power 10 - 2000 mhz dbm +10 ? ? noise figure ? 10 - 2000 mhz db ? ? 6.0 reverse transmission ? 10 - 2000 mhz db ? - 30 - 27 vswr ? 10 - 2000 mhz ratio ? ? 2.0:1 output ip 2 two - tone inputs up to 0 dbm 10 - 2000 mhz dbm +30 ? ? output ip 3 two - tone inputs up to 0 dbm 10 - 2000 mhz dbm +20 ? ? vbias ? ? v +14.5 +15.0 +15.5 ibias vbias = +15.0 vdc ? ma ? 52 60 power dissipation @ +15v bias ? mw ? 780 ? 2. all specifications apply when operated at +15 vdc, with 50 ohms source and load impedance. 3. heat sinking: operation at case temp erature above 95 c is not recommended. heat sinking adequate to dissipate 1.0w must be provided in use. s - parameter data s11 s21 s12 s22 mag ang mag ang mag ang mag ang 10 0.13 - 171.5 10.33 6.2 0.03 4.5 0.10 80.7 20 0.12 - 175.9 10.18 0.3 0.03 2.8 0.08 47.2 500 0.12 105.1 10.13 - 79.8 0.03 - 12.1 0.10 - 131.1 2000 0.28 176.9 9.63 53.4 0.01 - 75.0 0.30 - 142.7 frequency (mhz) 40 0.12 174.6 10.48 - 4.6 0.03 1.4 0.08 7.2 100 0.12 165.0 10.51 - 15.7 0.03 - 1.8 0.06 - 38.9 200 0.12 149.1 10.42 - 32.4 0.03 - 4.8 0.05 - 76.4 1000 0.12 9.8 9.60 - 156.4 0.03 - 27.2 0.12 173.5 1500 0.14 - 99.8 9.53 126.5 0.02 - 51.5 0.14 - 89.3
cascadable thin film amplifier, 20 db gain, 10 - 2000 mhz am - /amc - 184 specifications subject to change without notice. n north america: tel. (800) 366 - 2266 n asia/pacific: tel.+ 81 - 44 - 844 - 8296 , fax + 81 - 44 - 844 - 8298 n europe: tel. +44 (1344) 869 595, fax+44 (1344) 300 020 visit www.macom.com for additional data sheets and product information. v 3.00 typical performance curves noise figure 3 ordering information part number package am - 184 pin 4 to - 8 - 1 amc - 184 sma c - 32 1 db compression intermodulation intercept gain vs. frequency vswr vs. frequency 4. mounting kit part number au00071 required for pcb applications. 10 11 12 13 5 10 50 100 300 500 750 1000 1250 1500 1750 2000 frequency (mhz) output power (dbm) 10 20 30 40 5 10 50 100 300 500 750 1000 1250 1500 1750 2000 frequency (mhz) intercept (dbm) ip2 (f1+f2) ip3 ip2 (f1-f2) 4 5 6 7 5 10 50 100 300 500 750 1000 1250 1500 1750 2000 frequency (mhz) noise figure (db) +85c +25c 1.0 1.4 1.8 2.2 5 10 50 100 300 500 750 1000 1250 1500 1750 2000 frequency (mhz) vswr rf in rf out 19 20 21 22 5 10 50 100 300 500 750 1000 1250 1500 1750 2000 frequency (mhz) gain (db) +85c +25c -55c
|