12730 commonwealth drive ? fort myers, florida 33913 phone: 239-561-3311 ? 800-237-3061 fax: 239-561-1025 ? www.crystek.com crystek corporation microwave a division of crystek corporation notes: 1.0 materials 1.1 body, coupling, and cl amp nuts: steel. corrosi on resistant per astm-a582. uns no. s30300. 1.2 center conductor: beryllium copper per astm-b196. uns c17300. 1.3 solder ferrule: bra ss per astm-b16. uns c36000. 1.4 lock ring: be ryllium copper per as tm-b197. uns c17200. 1.5 gasket and o-ring: si licone rubber per a-a-59588. 1.6 dielectric bead: polyphenyl ene oxide (noryl ) per astm-d4349. 1.7 cable stop: polyet herimide thermoplastic (ult em 1000) pe r astm-d5205. 2.0 finishes 2.1 center contact and solder fe rrule: gold plate per astm-b488 50 microi nches min. thickness over electrolytic nickel plate per astm-b 689 50 microinches min. thickness. 2.2 body, coupling, and clamp nuts: passi vated per sae-ams-2700. 2.3 gasket, o-ri ng, lock ring, and di electrics: none. 3.0 interface: per cc-2.4mm-pin. page 1 of 2
12730 commonwealth drive ? fort myers, florida 33913 phone: 239-561-3311 ? 800-237-3061 fax: 239-561-1025 ? www.crystek.com crystek corporation microwave a division of crystek corporation product control: crystek part number: revision level: release date: responsible: a k. piotrowicz 04-jan-11 CS-DM-MJB note: distance from end of cable center conductor to ref. pl. is 0.270 (ref) 1.1 trim cable as shown. step 1 2.1 install o-ring on to clamp nut where shown and slide cl amp nut over cable in orientation shown. 2.2 insert cable into so lder ferrule until dielectr ic and foil are flush with solder ferrule face and solder cable braids where shown. 2.3 slide dielectric stop over cable center conductor and sold er contact flush to stop to dimension shown. step 2 3.1 insert cable/contact sub- assembly into connector until seated and tighten clamp nut to 25-35 in-lbs. step 3 page 2 of 2
|
