www.rfm.com e-mail: info@rfm.com page 1 of 3 ?2010 by rf monolithics, inc. XVT9012 - 6/8/10 electrical characteristics characteristic sym notes minimum typical maximum units nominal frequency fo 19.200000 mhz component storage temperature range -30 +85 c storage temperature range in tape and reel -30 +85 c soldering profile, 10 seconds, up to 5 cycles 260 c operating temperature range -20 +70 c power supply voltage vcc 3.14 3.30 3.46 v output voltage with load 10 pf||10 k ? vout 0.8 v p-p output waveform clipped sinewave power supply current icc 2.0 ma control voltage vcon 0.5 2.5 v control voltage input impedance 100k ohms frequency tolerance, single solder reflow, vcontrol = 1.50 v 2.0 ppm max @ 25 c 2 c frequency stability versus: temperature, -20 to 70 c 1.0 ppm supply voltage, 3.14 to 3.46 v 0.2 ppm load 10 pf||10 k ? 10% 0.2 ppm control voltage frequency range, 0.5 to 2.5 v 13 17 ppm/v start up time, 90% of final rf level in v p-p 5.0 ms aging @ 25 c 1 ppm/year harmonics -5.0 dbc ssb phase noise @ 1 khz carrier offset -130 dbc/hz lid symbolization 9012/ywws sm3225-4 case ? voltage controlled temperature compensated crystal oscillator excellent frequency stability & low phase noise 3.2 x 2.5 x 1.2 mm surface-mount case complies with directive 2002/95/ec (rohs) 19.200000 mhz vctcxo XVT9012 caution: electrostatic sensitive device. observe precautions for handling. notes: 1. the design, manufacturing process, and specifications of this device are subject to change without notice. pb preliminary
www.rfm.com e-mail: info@rfm.com page 2 of 3 ?2010 by rf monolithics, inc. XVT9012 - 6/8/10
4-terminal surface-mount seam weld case 3.2 x 2.5 mm nominal footprint sm3225-4 case application circuit pin connection 1vcon 2 gnd/case gnd 3 output 4vcc
www.rfm.com e-mail: info@rfm.com page 3 of 3 ?2010 by rf monolithics, inc. XVT9012 - 6/8/10 reel dimensions tape dimensions mm a0 b0 w f e p0 p1 p2 d1 d k0 t dimension 2.80 3.71 8.00 3.50 1.75 4.00 4.00 2.00 1.50 1.00 1.75 0.25 tolerance 0.10 0.10 +0.30/-0.10 0.05 0.10 0.10 0.10 0.05 +0.10/-0.00 +0.25/-0.00 0.10 0.02 mm a b c d e f g h t1 t2 t3 dimension 180 60 13.0 2.0 9.1 2.9 4.9 3.9 9.0 11.4 1.2 tolerance 1.0 +1.0/-0.0 0.2 0.5 0.5 0.5 0.5 0.5 0.3 1.0 0.1
|