pll602-00 multiplier xo ic die for 12 to 25mhz parallel re sonant crystals 47745 fremont blvd., fremont, california 94538 tel (510) 492-0990 fax (510) 492-0991 www.phaselink.com rev 09/03/04 page 1 features ? integrated crystal oscillator circuitry (xo). ? low phase noise (-135dbc @ 10khz offset) selectable frequency multipliers (x1, x2, x4, x8 as bonding options). ? 3.3v supply voltage. ? uses inexpensive fundamental-mode parallel resonant crystals (from 12 to 25mhz). ? selectable high drive (30ma) or standard drive (10ma) output. ? available in die (65 mil x 62 mil). description the pll602-00 is a monolithic low jitter and low phase noise (-135dbc @10khz offset), high performance cmos xo ic. this flexible device can be used as a xo with output frequencies ranging from f xin x 1 to f xin x 8 thanks to selector pads allowing bonding options (see divider selection table on this page). this makes the pll602-00 ideal for a wide range of applications from 12mhz to 200mhz (including 50mhz, 77.76mhz, 125mhz and 155.52mhz, etc.). block diagram die specifications name value size 62 x 65 mil reverse side gnd pad dimensions 80 micron x 80 micron thickness 10 mil die configuration multiplier selection selection s2 s1 s0 f xin clk (mhz) 0 0 0 f xin x 2 0 0 1 f xin x 4 0 1 0 f xin x 1 1 0 0 f xin x 8 0 1 1 f xin x 2* 1 1 0 f xin x 4* 1 0 1 f xin x 1* 1 1 1 12mhz ? 25mhz f xin x 8* note: - selector pads default to ?0?, wire bond to vdd to set to ?1? - (*) high-drive cmos output pad description name number description xin 27 crystal input connection. xout 29 crystal connection. gnd 7,10 ground. clk 13 clock output. s[0:2] 18,19,20 frequency selection pad vdd 21,22,23 3.3v power supply. oe 25 output enable: ?0? to disable (tri- state output), 1? (default value when not connected) to enabled the output. xin xo clk selectable pll xout s[0:2] 18 19 20 21 23 25 7 13 10 27 29 y x (0,0) (1550,1475) 62 mil 65 mil gnd clk gnd xout xin oe^ vdd vdd s0 v s1 v s2 v die id: a0303-03h c502a note: ^ denotes internal pull up v denotes internal pull down
pll602-00 multiplier xo ic die for 12 to 25mhz parallel re sonant crystals 47745 fremont blvd., fremont, california 94538 tel (510) 492-0990 fax (510) 492-0991 www.phaselink.com rev 09/03/04 page 2 electrical specifications 1. absolute maximum ratings parameters symbol min. max. units supply voltage v dd 4.6 v input voltage, dc v i -0.5 v dd +0.5 v output voltage, dc v o -0.5 v dd +0.5 v storage temperature t s -65 150 c ambient operating temperature* t a -40 85 c junction temperature t j 125 c lead temperature (soldering, 10s) 260 c esd protection, human body model 2 kv exposure of the device under conditions beyond the limits specif ied by maximum ratings for extended periods may cause permanent damage to the device and affect product reliability. thes e conditions represent a stress rating on ly, and functional operations of the devic e at these or any other conditions above the operational limits noted in this spec ification is not implied. * note : operating temperature is guaranteed by design for all parts (commercial and industrial), but tested for commercial grade only . 2. dc electrical specifications parameters symbol conditions min. typ. max. units supply current, dynamic, with loaded outputs i dd f xin = 12 - 25mhz output load of 10pf 16 20 ma operating voltage v dd 2.97 3.63 v i oh v oh = v dd -0.4v, v dd =3.3v 30 ma output drive current (high drive) i ol v ol = 0.4v, v dd = 3.3v 30 ma i oh v oh = v dd -0.4v, v dd =3.3v 10 ma output drive current (standard drive) i ol v ol = 0.4v, v dd = 3.3v 10 ma short circuit current 50 ma 3. ac electrical specifications parameters symbol conditions min. typ. max. units input crystal frequency 12 25 mhz output clock rise/fall time (standard drive) 0.3v ~ 3.0v with 15 pf load 2.4 output clock rise/fall time (high drive) 0.3v ~ 3.0v with 15 pf load 1.2 ns output clock duty cycle measured @ 50% v dd 45 50 55 %
pll602-00 multiplier xo ic die for 12 to 25mhz parallel re sonant crystals 47745 fremont blvd., fremont, california 94538 tel (510) 492-0990 fax (510) 492-0991 www.phaselink.com rev 09/03/04 page 3 4. crystal specifications parameters symbol conditions min. typ. max. units crystal resonator frequency f xin parallel fundamental mode 12 25 mhz crystal loading rating c l (xtal) 20 pf recommended esr r e at cut 30 ? 5. jitter and phase noise specification parameters conditions min. typ. max. units at 155mhz, with capacitive decoupling between vdd and gnd. 4 at 80mhz, with capacitive decoupling between vdd and gnd. 3 rms period jitter (1 sigma ? 1000 samples) at 44mhz, with capacitive decoupling between vdd and gnd. 2.5 ps phase noise relative to carrier 44m hz @100hz offset -80 dbc/hz phase noise relative to carrier 44m hz @1khz offset -110 dbc/hz phase noise relative to carrier 44m hz @10khz offset -135 dbc/hz phase noise relative to carrier 44m hz @100khz offset -130 dbc/hz phase noise relative to carrier 44m hz @1mhz offset -132 dbc/hz phase noise relative to carrier 155m hz @100hz offset -80 dbc/hz phase noise relative to carrier 155m hz @1khz offset -110 dbc/hz phase noise relative to carrier 155m hz @10khz offset -125 dbc/hz phase noise relative to carrier 155m hz @100khz offset -120 dbc/hz phase noise relative to carrier 155m hz @1mhz offset -125 dbc/hz
pll602-00 multiplier xo ic die for 12 to 25mhz parallel re sonant crystals 47745 fremont blvd., fremont, california 94538 tel (510) 492-0990 fax (510) 492-0991 www.phaselink.com rev 09/03/04 page 4 pad assignment pad # name x ( m) y ( m) description 7 gnd 1042 109 ground. 10 gnd 1400 259 ground. 13 clk 1400 716 cmos clock output. 18 s2 1232 1365 used to select multiplication factor and drive level. internal pull down. 19 s1 1042 1365 used to select multiplication factor and drive level. internal pull down. 20 s0 854 1365 used to select multiplication factor and drive level. internal pull down. 21 vdd 659 1365 3.3v power supply. 23 vdd 459 1365 3.3v power supply. 25 oe 194 1365 used to enable/disable the output(s). internal pull up. 27 xin 109 1017 crystal input. see crystal specification page 3. 29 xout 109 646 crystal output. se e crystal specification page 3. ordering information phaselink corporation, reserves the right to make changes in its products or specifications, or bo th at any time without notice . the information furnished by phaselink is believed to be accurate and reliable. however, phaselink makes no guarantee or warranty concerning t he accuracy of said information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product. life support policy : phaselink?s products are not authorized for use as critical components in life support devices or systems without the express written approval of the president of phaselink corporation. for part ordering, please contact our sales department: 47745 fremont blvd., fremont, ca 94538, usa tel: (510) 492-0990 fax: (510) 492-0991 part number the order number for this device is a combination of the following: device number, package type and operating temperature range pll602-00 d c order number marking package option pll602-00dc P602-00DC die ? waffle pack part number temperature c=commercial i=industral package type d=die
|
