28 type of load life (min.) cycles x 10 3 28 vdc 115vac 400hz resistive inductive motor lamp 100 20 100 100 * 60 hz loads rated for 10,000 operations ratings are continuous duty overload current 40 amps dc, 60 amps 400hz rupture current 50 amps dc, 80 amps 400hz contact make bounce 1 millisecond at nominal voltage max. contact drop at 10 amps: initial 0.100 volts. end of life 0.125 volts contact rating-amperes hermetically sealed all welded construction balanced force permanent magnet drive 6pdt switching in 1.4 cu inch contacts: silver cadmium oxide with gold plating coils for dc and 400 hz weight 4.16 ounces max. (117.94 grams max.) 115/200vac 400hz-30 10 8 4 2 10 8 4 2 10 8 4 2 the series fca-610 relay is a polarized single-side stable design, where the flux from a permanent magnet provides the armature holding force in the deactivated state, and its flux path is switched and combined with the coil flux in the operated state. this results in appreciably increased contact pressure in both states over that of a spring return nonpolar design. we also manufacture 2-pole and 4-pole versions of this relay. fca-210 : 10 amp dpdt relay fca-410: 10 amp 4pdt relay fca-610 10 amperes, 6pdt series tyco electronics mid-range military/aerospace relays qpl approved q ualified to m il-r -83536
29 coil data nominal voltages freq. hz dc res. ac amps (b) pickup or below volts over temperature range coil code must hold voltage (c) dropout or above volts general specifications temperature rating: altitude: shock:* vibration, sinusoidal:* vibration, random: * dielectric strength at sea level: dielectric strength at 80,000 feet: insulation resistance: operate time at nominal voltage: release time at nominal voltage: 1 2 3 4 (a) 5 8 6 12 28 28 48 115 dc dc dc dc dc 400h z 8.5 ? 33 ? 180 ? 180 ? 530 ? 60 ma 4.5 9.0 18.0 18.0 32.0 90.0 0.3 0.75 1.5 1.5 2.5 5.0 2.5 4.5 7.0 7.0 14.0 40.0 z, y & x enclosures z, y & x enclosures z, y & x enclosures all circuits to ground and circuit to circuit. coil to ground initial (500 vdc) after life or environmental tests dc relays ac relays dc relays ac relays a. code 4 coils have back emf suppression to 42 volts max. b. dc coil resistance 10% at 25?c; ac coil max. current at nominal voltage. c. relay will stay in picked-up state down to must hold voltages shown. d. max. overvoltage: 6 & 12 vdc coils 120% of nominal; all others 110% of nominal. e. coils available for other voltages and for ac 50/60hz. note: only dc coil models are qpl approved. -70?c to + 125?c 300,000 feet 50 g for 6 to 9 ms 20 g to 2000hz 0.3 g 2 /hz 50-2000hz 1250 v rms 1000 v rms 350 v rms 100 m ? minimum 50 m ? minimum 15 ms or less 20 ms or less 15 ms or less 50 ms or less * max. contact opening under vibration or shock 10 microseconds fca-610 10 amperes, 6pdt series tyco electronics mid-range military/aerospace relays
30 .050 .005 (1.27 (3) silicone rubber gasket .270 (6.86) below are shown the standard terminal types and the enclosures available. note that the pin configuration for coil connections is determined by the coil supply voltage. specify the assembly as indicated under how to order. dimensions are shown in inches .010 and (millimeters .25) except as noted. terminals terminals on 0.200 centers. coil terminals: x1-x2; see page 30. socket pins are gold plated. circuit board pins are tin/lead plated. code "a" socket pins-all dc coils enclosures all enclosures have cupro-nickel cans bright acid tin/lead plated after assembly to terminal headers. code "z" .040 (1.02) .150 (3.81) 1.00 (25.4) 1.483 max. (37.67) 1.410 (35.81) 1.010 max. (25.65) .156 (3.96) 1.708 max. (43.38) code "y" code "x" .150 (3.81) 1.00 (25.4) 1.483 max. (37.67) 1.410 (35.81) 1.708 max. (43.38) .040 (1.02) 1.010 (25.65) 1.462 (37.13) 1.412 (35.86) 1.053 max (26.75) 1.462 (37.13) 1.412 (35.86) 1.053 max (26.75) code "b" .270 (6.86) circuit board pins-all dc coils -x2 +x1 .062 .001 dia.pin (1.57 .02 ) 20 places blue bead -x2 +x1 blue bead .062 dia. pin (1.57 ) 20 plcs. + .002 - .001 + .05 - .02 solder hooks-ac or dc coils code "c" code "d" socket pins-all ac coils .050 .005 (1.27 (3) silicone rubber gasket .270 (6.86) blue bead .300 .010 (7.26) .254 0.80 dia (2.03) -x2 +x1 blue bead .062 dia. pin (1.57 ) 20 plcs. + .002 - .001 + .05 - .02 code "f" circuit board pins-all ac coils .270 (6.86) blue bead .062 dia. pin (1.57 ) 20 plcs. + .002 - .001 + .05 - .02 +x1 -x2 .062 .001 dia.pin (1.57 .02 ) 20 places 1.483 max. (37.67) 1.010 max. (25.65) 1.053 max. (26.75) x1 x2 fca-610 10 amperes, 6pdt series tyco electronics mid-range military/aerospace relays
31 all dc coils & ac solder hooks dc coils with transient suppression ac coils (socket pins) terminal wiring 2 3 x2 - a b c d e f 1 x1 + blue bead + 2 3 x2 - a b c d e f 1 x1 + blue bead + 2 3 a b c d e f + x2 x1 blue bead 1 note: polarity must be observed with dc coil supply. relay is polarized with a permanent magnet and will not operate or be damaged by reverse polarity. diodes used in transient suppression and in ac rectifier circuits have peak inverse voltage rating of 600 vdc minimum. zener diodes have a minimum rating of 1 watt. terminal designations are for reference only and do not appear on the header. -x2 +x1 blue bead .400 (10.16) .200 (5.08) .600 (15.24) .200 (5.08) terminal layout .400 (10.16) how to order (example) relay type terminals (socket pins dc coils) enclosure (with flanges) coil (28 vdc with transient suppression). note: only dc coil models are qpl approved fca-610- a y 4 .600 (15.24) .800 (20.32) 1.00 (25.4) fca-610 10 amperes, 6pdt series tyco electronics mid-range military/aerospace relays
|
