page 1 of 3 dc/dc converters tsr-3 series, 3 a features high performance 3 amp. switching regulator suitable for positive & negative output circuit high effciency up to 95 % adjustable output voltages wide input voltage ranges 2.5C5.5, 4.5C14 and 10C30 vdc over-temperature protection short circuit protection remote on/off input low output ripple & noise 3-year product warranty the tsr 3 models are non isolated step down switching regulators. since production may 2013 they can also be operated with negative output voltage. they come in a very compact open frame package of 15.5 x 9.4 x 6.2mm. the high effciency of up to 95% admits a full load operation up to 50c and up to 85c with 50% current reduction. a low standby current, a very wider input range and no requirement for heatsink give these switching regulators a signifcant advantage over linear regulators. togther with a remote on/off input and protection against short circuit and over temperature the tsr 3 series models are ideal point of load regulators for high reli - able and energy critical applications. order code * input voltage range output voltage adjustable 6) output current max. effciency typ. positive output circuit tsr 3-0533 2.5 C 5,5 vdc 1) 0.6 C 3.3 vdc 95 % at 2.5 vdc tsr 3-1250 4.5 C 14 vdc 2) 0.59 C 6.0 vdc 93 % at 3.3 vdc tsr 3-2450 10 C 30 vdc 3) 3.0 C 6.0 vdc 3 a 91 % at 5.0 vdc tsr 3-24150 10 C 30 vdc 3) 5.0 C 15 vdc 95 % at 12 vdc negative output circuit tsr 3-1250 4.7 C 13 vdc 4) -0.59 C -6.0 vdc 1.5 a at |vout| >3.3 vdc 2.2 a at |vout| <3.3 vdc 90 % at -3.3 vdc tsr 3-2450 10 C 27 vdc 5) -3.0 C -6.0 vdc 2.2 a 90 % at -5.0 vdc tsr 3-24150 10 C 25 vdc 5) -5.0 C -15 vdc 1.2 a 91 % at -12 vdc models * suffx a for models with angular pins (see dimensions), availability on demand, no stocking item. 1) input voltage must be at least 0.5 v higher than output voltage 2) input voltage must be at least 2.0 v higher than output voltage, max. 9 vdc if output is <0.9 vdc 3) input voltage must be at least 3.0 v higher than output voltage 4) max. input voltage = 14-|vout| 5) max. input voltage = 30-|vout| 6) open trim input = min. output voltage http://www.tracopower.com
input specifications maximum input current (@ vin min. and 3 a output current) tsr 3-0533: 3.0 a tsr 3-1250: 2.6 a tsr 3-2450: 2.2 a tsr 3-24150: 3.0 a no load input current C positive output circuit 25 ma typ. C negative output circuit 35 ma typ., 60 ma typ. for tsr 3-24150 reflected ripple current C positive output circuit tsr 3-0533 and tsr 3-1250: 30 ma typ. tsr 3-2450 & tsr 3-24150: 30 ma typ. with ext. filter, see fig. 1 page 3 C negative output circuit all models: 30 ma typ. with ext. filter, see fig. 2 page 3 input filter internal capacitors output specifications voltage set accuracy 2 % (at full load) output voltage adjustment see application note page 3 regulation C input variation >2.5 vout: 0.2 %, <2.5 vout: 5 mv C load variation 0 C 100 % >2.5 vout: 0.8 %, <2.5 vout: 20 mv C load variation 10 C 90 % >2.5 vout: 0.6 %, <2.5 vout: 15 mv temperature coefficient 0.015 %/c max. overshoot startup voltage 1.0 % max. minimum load not required ripple and noise (20 mhz bandwidth) tsr 3-0533: 30 mvp-p tsr 3-1250: 60 mvp-p tsr 3-2450: 75 mvp-p tsr 3-24150: 150 mvp-p dynamic load response 50 % load change (upper half) 150 mv max. peak variation (250 mv max. for tsr 3-24150) 250 s max. response time startup rise time 10 % to 90 % vout tsr 3-0533 & tsr 3-1250: 7 ms tsr 3-2450 & tsr 3-24150: 10 ms short circuit protection indefinite, automatic recovery current limitation tsr 3-0533: 280 % typ. other models: 220 % typ. capacitive load C esr > 1 mohm tsr 3-24150: 500 f max. other models: 1000 f max. C esr > 10 mohm tsr 3-24150: 1200 f max. other models: 3000 f max. general specifications temperature ranges C operating C40c to +85c C storage C55c to +125c derating 1.5 %/k above +50c thermal shock acc. mil-std-810f humidity (non condensing) 95 % rel h max. reliability, calculated mtbf (mil-hdbk-217f, at +25c, ground benign) >1630000 h i/o isolation voltage none switching frequency tsr 3-0533 & tsr 3-1250: 600 khz typ. tsr 3-2450 & tsr 3-24150: 300 khz typ. remote on/off C on tsr 3-0533: open or vin (pin 1 ref. to gnd) other models: open or 1 to 12 vdc C off 0 to 0.3 vdc C off idle current: tsr 3-0533 & tsr 3-1250: 1.5 ma typ. tsr 3-2450 & tsr 3-24150: 6 ma typ. environmental compliance C reach www.tracopower.com/products/tsr3-reach.pdf C rohs rohs directive 2011/65/eu dc/dc converters tsr-3 series 3 a all specifcations valid at nominal input voltage, full load and +25c after warm-up time unless otherwise stated. page 2 of 3 http://www.tracopower.com
outline dimensions dc/dc converters tsr-3 series 3 a rev. february 14. 2014 pin-out positive negative 1 remote on/off 2 +vin (vcc) 3 gnd Cvout 4 +vout gnd 5 trim page 3 of 3 dimensions in [mm], () = inch pin pitch tolerances: 0.25 (0.01) pin profile tolerance: 0.1 (0.004) other tolerances: 0.5 (0.02) applications notes input filter to reduce reflected ripple current c1 = 220 f, esr <0.1 ohm c2 = 150 f l1 = 1 h output voltage adjustment (for negative and positive circuit) 4 x 1.70 3.7 6.0 3.3 h (4 x 0.06) (0.14) (0.24) (0.13) 1 5s quare pins 0.64 x 0.64 (0.025 x 0.025) w tsr 3-0533 & tsr 3-1250: w=9.4 (0.37) h=15.5 (0.61) tsr 3-2450 & tsr 3-24150: w=10.4 (0.41) h=16.5 (0.65) 5.1 6.2 (0.20) (0.25) c1 input tsr 3 c2 l1 gnd 24 3 gnd + + output load 4 3 tsr 3 rtrim 5 model r trim [kohm] 1/16 w tsr 3-0533 1.2/(|vout| -0.6)-0.01 tsr 3-1250 1.18/(|vo u t| - 0.59 ) tsr 3-2450 11. 2 /(|vo u t| -3 ) tsr 3-24150 8.4/(|vout| -5) weight tsr 3-0533 & tsr 3-1250: 1.7 g tsr 3-2450 & tsr 3-24150: 2.1 g c2 24 3 input tsr 3 c1 + gnd gnd outpu t positive output circuit negative output circuit c1, c2 =10 f, mlcc fig. 1 fig. 2 angular pin version (optional) standard version (|vout| = absolute value) sp ec i?cati ons can be changed wi thout noti ce! make sure you are using the latest documentation, downloadable at www.tracopower. com www .tracopower. com
|