series am3gw-z 3 watt | dc-dc converter www.aimtec.com tel: +1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.f 1 of 5 north america only features: ? sip9 package ? ? low ripple and noise ? ? continuous short circuit protection ? ? -40oc to +85oc operating temperature range ? models single output model input voltage (v) output voltage (v) output current max (ma) maximum capacitive load (f) efficiency (%) am3gw-2403sz 9-36 3.3 700 2200 77 am3gw-2405sz 9-36 5 600 1000 82 am3gw-2412sz 9-36 12 250 165 83 am3gw-2415sz 9-36 15 200 100 83 am3gw-4803sz 18-75 3.3 700 2200 78 am3gw-4805sz 18-75 5 600 1000 84 am3gw-4812sz 18-75 12 250 165 84 am3gw-4815sz 18-75 15 200 100 82 models dual output model input voltage (v) output voltage (v) output current max (ma) maximum capacitive load (f) efficiency (%) am3gw-2405dz 9-36 5 300 470 81 am3gw-2412dz 9-36 12 125 100 84 am3gw-2415dz 9-36 15 100 47 83 am3gw-4805dz 18-75 5 300 470 82 am3gw-4812dz 18-75 12 125 100 82 am3gw-4815dz 18-75 15 100 47 83 note: all specifications in this datasheet are measured at an ambient temperature of 25c, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. input specifications parameters nominal typical maximum units voltage range 24 48 9-36 18-75 vdc filter capacitor start up time 10 ms absolute ma ximum rating 24 48 50 100 vdc peak input voltage time 100 ms on/off control on: 0 to 0.6vdc (or open) ; off:2.7 to 15.0vdc, off idle current: 5ma, max input reflected ripple current 20 ma p-p isolation specifications parameters conditions typical rated units tested i/o voltage 3 sec 1500 vdc resistance >1000 mohm capacitance 500 pf
series am3gw-z 3 watt | dc-dc converter www.aimtec.com tel: +1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.f 2 of 5 north america only output specifications parameters conditions typical maximum units voltage accuracy 1 % cross regulation (dual output models) 25% load on one output - 100% load on second load 5 % short circuit protection hiccup continuous short circuit restart auto-recovery line voltage regulation ll~hl 0.5 % load voltage regulation from 10% to 100% load from 0% to 100% load 12vout and 15vout from 0% to 100% load 3.3vout and 5vout 0.5 0.5 1 % ripple & noise 20mhz bandwidth 50 mv p-p transient response deviation 3 % transient recovery time 300 s general specifications parameters conditions typical maximum units switching frequency 100% load 250 khz operating temperature -40 to 85 o c storage temperature -40 to +125 o c temperature coefficient 0.02 %/ o c maximum case temperature 100 o c derating above 75c 3.5 %/c cooling free air convection humidity 95 % rh case material non conductive black plastic potting material epoxy (ul94v-0 rated) weight 6.5 g dimensions (l x w x h) 1.02 x 0.36 x 0.49 in ches 25.91 x 9.14 x 12.44 mm mtbf >1,212,000 hrs (mil-hdbk -217f , ground benign, t=+25oc) max soldering temperature 1.5mm from case 10 second 260 o c safety specifications parameters agency approval ce standards en55022 class a, iec61000-4-2, perf. criteria b iec61000-4-3, perf. criteria a iec61000-4-4, perf. criteria b (e xternal 220uf/100v cap required) iec61000-4-5, perf. criteria b (e xternal 220uf/100v cap required) iec61000-4-6, perf. criteria a iec61000-4-8, perf. criteria a note: designed to meet iec 60950-1:2001 pin out specifications pin single dual 1 - v input - v input 2 + v input + v input 3 on/off control on/off control 6 + v output + v output 7 nc common 8 nc nc 9 - v output -v output
series am3gw-z 3 watt | dc-dc converter www.aimtec.com tel: +1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.f 3 of 5 north america only dimensions all dimensions are in millimeters (inches) pin diameter: 1.0 0.05 ( 0.04 0.002 ) pin pitch tolerance: 0.35 ( 0.014 ) case tolerance: 0.5 ( 0.02 ) derating
series am3gw-z 3 watt | dc-dc converter www.aimtec.com tel: +1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.f 4 of 5 north america only test circuits conducted emissions: models c1 l1 am2gw-24xx-z 1210,225k/100v,x7r, 2pcs 6.8h am2gw-48xx-z 1210,105k/100v,x7r 56h input reflected ripple current: lin 12h cin 47f, esr<1 ? at 100khz measurement taken at nominal input and full load.
series am3gw-z 3 watt | dc-dc converter www.aimtec.com tel: +1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.f 5 of 5 north america only control on/off pin connection example: the voltage could be applied trough a limiting resistor. the conv erter is turned on the external switching circuit is open. note: 1. datasheets are updated as needed and as such, specifications ar e subject to change without notic e. once printed or downloaded , datasheets are no longer controlled by aimtec; refer to www.aimtec.com for the most current product specifications. 2. product labels shown, including safety agency cert ifications on labels, may vary based on the date manufactured. 3. mechanical drawings and specifications are for reference only. 4. all specifications are measured at an am bient temperature of 25c, humidity<75%, nominal input voltage and at rated output load unless otherwise specifie d. 5. aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. cas numbers and other limited information are considered proprietary an d may not be available for release. 6. this product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control sys tems or other such applications which necessitate specific safety and regulatory standards ot her the ones listed in this datasheet. 7. warranty is in accordance with aimtec?s st andard terms of sale available at www.aimtec.com.
|
