View M1D-600D1_8829787.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

issued date : 11/15/2012 specification a?? a?? a?? a?? a?Q a?Q a?Q a?Q / model name M1D-600D1 a? a? a? a? / description:600w power supply for 1u easy swap C 72pins. 5 outputs (+12v, +5v, -12v,+3.3v, 5v sb) / revision 1.1 ??o ??o ??o ??o / revision history rev. date revision description ? ? ? ? modify by ?J ?J ?J ?J cust. approval J J J J app. date 1.0 aug. .08, 2011 modified the circuit for dc-dc backplane kevin chen aug.10, 2011 1.1 nov. 15, 2012 add the he/ln stick and description. mindy chung nov. 16, 2012 ? / prepared by z / checked by ? / approved by kevin jacky sure star sure star
? contents 1. general description 2. ?? ?? ?? ?? input characteristics 2.1. ??l? ac input voltage and frequency 2.2. ?c? input current and inrush current 2.3. power factor 3. power efficiency 4. ?? ?? ?? ?? output characteristics 4.1. ??{ output voltage & current regulation 4.2. ?y dc output ripple & noise 4.3. ??rg hold up time 4.4. rg rise time 4.5. ?B? rg dynamic load response time 4.6. h_P remote on/off control 5. ?? ?? ?? ?? power good signal 6. o o o o protection 6.1. ^o over voltage protection 6.2. ?o under-voltage protection 6.3. ^o over current protection 6.4. o short circuit protection 7. ??B ??B ??B ??B power system signal status 7.1. QB buzzer status 7.2. ??? led indicators 7.3. ttl ? ttl signal 8. ?d ?d ?d ?d load sharing sure star sure star
9. ^ ^ ^ ^ isolation 9.1. ^ insulation resistance 9.2. ?^ dielectric withstand voltage 9.3. ? leakage current 10. ? ? ? ? ? ? ? ? safety requirements 11. ? ? ? ? emc 11.1. ? ?_ emi 11.2. ? ems 12. hl hl hl hl environmental 12.1. ? temperature 12.2. h humidity 12.3. ? altitude 12.4. vibration 12.5. n shock 12.6. s? cooling method 13. ? ? ? ? reliability 13.1 ??rg mtbf qualification 14. C? C? C? C? ?B ?B ?B ?B mechanical 2d drawing and power connector 14.1. ^?D outside dimension 14.2. ? dc output pin assignment sure star sure star
1. general description this specification describes the performance charac teristics of a 600 watts easy swappable, power system with +3.3v,+5v,+12v, -12v main dc outp uts, and 5v standby outputs. sure star model M1D-600D1. 2. ?? ?? ?? ?? input characteristics 2.1. ?? l ac input voltage and frequency ? minimum ? nominal ? maximum unit 90 100~240 264 vac 47 50~60 63 ? hz 2.2. ?c input current and inrush current ?? ac input voltage ? max. input current per power supply module ? inrush current per power supply module 115vac 10a 25a 230vac 5a 50a 2.3. power factor 90vac 115vac 230vac 264vac 0.99 0.98 0.95 0.92 3. power efficiency ?MdB 115 60 ?? ?? 80%(min) the minimum efficiency of the power supply is 80% a t full load and 115vac/60hz input. sure star sure star
4. ?? ?? ?? ?? output characteristics 4.1. ??{ output voltage & current regulation ?? output voltage min. current ~ rated current { regulation +3.3v 1a 25a 5 +5v 1a 25a 5 +12v 1a 49a 5 -12v 0a 1a 5 +5vsb 0.5a 3.5a 5 note: 5v 3.3v ??^ 180 . the combined total power from 5v & 3.3v shall not e xceed 180w. 4.2. ?y dc output ripple & noise output voltage ripple & noise (max.) +3.3v 60mvp-p +5v 60mvp-p +12v 120mvp-p -12v 120mvp-p +5vsb 50mvp-p note: 1. y lO 20 ?? ripple & noise bandwidth is set to 20mhz 2. ??K?? 0.1 uf ??? 10 uf ??y? y use a 0.1uf ceramic capacitor in parallel with a 10 uf electrolytic capacitor at output connector terminals for ripple & noise me asurements 4.3. ??rg hold up time output voltage 115vac input 230vac input +3.3v 16ms 16ms +5v 16ms 16ms +12v 16ms 16ms -12v 16ms 16ms +5vsb 16ms 16ms note: ??MdB all of dc output at full load. sure star sure star
4.4. rg rise time output voltage 115/230vac input & full load +3.3v 20ms (max.) +5v 20ms (max.) +12v 20ms (max.) -12v 20ms (max.) +5vsb 20ms (max.) note: rg?? 10% 90% ?rg the rise time measured is when the output voltages rise from10% to 90% of specified output voltage vout observed on the chann el waveform. 4.5. ?B? rg dynamic load response time the following shall apply to the 3.3 v, 5 v, and 12 v outputs: output voltage for each output shall recover to wit hin 5 % of its steady state level in less than 1 ms under the following conditions: ac input voltage: 90vac ~ 264vac repetition rate of 100hz with 50 % duty cycle output step load size load slew rate capacitive loa d +3.3v 30% to 100% to 30% load 0.5 a/ u sec 6000uf +5v 30% to 100% to 30% load 0.5 a/ u sec 6000uf +12v 60% to 100% to 60% load 1 a/ u sec 6000uf +5sb 0% to 100% to 0% load 0.5 a/ u sec 350uf 4.6. h_P remote on/off control the main outputs of this power supply (3.3v,5v,12v ,-12v) shall be energized when input signal*pson is active. *pson is an active low ttl c ompatible signal referenced to the +5v standby common. this input signal shall be an open collector signal capable of sinking a minimum of 1.6ma. when *pson becomes inactive, the main outputs shall be disabled. psu on psu off pson signal low (0.8v max) hi (2v max) sure star sure star
5. ?? ?? ?? ?? power good signal the system shall have an active high ttl compatible signal capable of sinking 1ma and sourcing 100ua. the signal shall become active with in 100 to 500 ms from the instant +5v output reaches a steady state level within the specified r egulation limits. it shall become inactive at le ast 1 ms before +5v drops to below the lower regulation limit. power good @ 115/230vac , full load 200ms ~ 500ms power fail @ 115/230vac , full load 1ms (min.) 6. o o o o protection 6.1. ^o over voltage protection output min max comments +3.3v 3.75v 4.3v psu shutdown +5v 5.7v 6.9v psu shutdown +12v 13v 14.3v psu shutdown note ??? 230 pd d?y? the power supply shall be test at max ac voltage (2 30vac) and min load or no load. 6 .2. ?o under-voltage protection output min max comments +3.3v 2.0v 2.4v psu shutdown +5v 3.3v 3.7v psu shutdown +12v 8.5v 9.5v psu shutdown note ??? 230 pd d?y? the power supply shall be test at max ac voltage (2 30vac) and min load or no load. 6 .3. ^o over current protection output over current(type) over current(max.) comments +3.3v R 27.5a 37.5a psu shutdown +5v R 27.5a 37.5a psu shutdown +12v R 53.9a 73.5a psu shutdown note ^oy?~?dry? the over current protection should be tested at oth er load rating. sure star sure star
6.4. o short circuit protection output comments +3.3v psu shutdown +5v psu shutdown +12v psu shutdown note oy? ~?dry? the short circuit protection should be tested at ot her load rating. 7. ??B ??B ??B ??B power system signal status 7.1. QB buzzer status power supply condition buzzer status no ac power to all psu off ac present/only standby output on off power supply dc outputs on and ok off power supply failure beeping 7.2. ??? led indicators power supply condition power system status per power module status led color red green orange no ac power to all psu off off off ac present/only standby output on on off off power supply dc outputs on and ok off on on power supply failure off blinking off sure star sure star
7.3. ttl ? ttl signal output condition power supply condition min. max. normal(power supply on) 3v 5.25v failure(power supply off) 0v 1v 8. ?d ?d ?d ?d load sharing ?? output voltage ?d load current ?d ? load share voltage +12v 1a +0.48v ~ +0.52v +5v 1a +0.33v ~ +0.37v +3.3v 1a +0.33v ~ +0.37v 9. ^ ^ ^ ^ isolation 9.1. ^ insulation resistance input to output 500vdc , 50m ohms min.( at room temperature) input to fg 500vdc , 50m ohms min.( at room temperature) output to fg non insulation 9.2. ?^ dielectric withstand voltage input to output 1834vac (30 ma) for 1 minute. input to fg 1834vac (30 ma) for 1 minute. output to fg non insulation 9.3. ? leakage current 120-264 /50-60 ?r? 3.5ma 3.5ma max. at 120~264vac/50~60hz. 10. ? ? ? ? ? ? ? ? safety requirements -cb report: iec 60950-1:2005 -tuv en 60950-1: 2006 + a11. -ul or cul 60950-1: 2 nd edition. -bsmi : r36530 -ccc : cnca-01c-020:2007 sure star sure star
11. ? ? ? ? emc ??? _M?? the power supply shall comply with the following cr iterion: 11.1. ?? _ emi 1) conduction emission: ?_ a.en55013/en55022, class b b.cispr13:2001/fcc part15 class b 2) radiated emission : ( ?_ ) a.en55013/en55022, class b b.cispr13:2001/fcc part15 class b 12. hl hl hl hl environmental 12.1. temperature operating : 0 to +40 non operating: -20 to +70 12.2. humidity operating : 5% to 95%, non-condensing non operating: 20% to 90%,non-condensing 12.3. altitude operating: sea level to 7,000 feet non-operating: sea level to 40,000 feet 12.4 . vibration 10-55hz, 19.6m/s2(2g), 3minutes period, 60minutes e ach along x, y and z axis. 12.5 . n shock 49m/s2(5g),11ms, once each x, y and z axis. 12.6. s? cooling method by ball bearing dc fan. 13. ? ? ? ? reliability 13.1 ??rg mtbf qualification using mil - hdbk -217f the calculated mtbf 100,000 hours at 25 sure star sure star
? 14. C? C? C? C? ?B ?B ?B ?B mechanical 2d drawing and power connector 14.1. outside dimension:227(d)x98.5(w)x40.10(h)mm 14.2. dc output pins assignment: 72pins golden fing er.

▲Up To Search▲

Price & Availability of M1D-600D1

	To Download M1D-600D1 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .