ilpa35ju series 35w water - proof constant current led driver C wide input voltage 90 to 305vac, 47 to 63hz C constant current output C high efficiency (up to 88%) C active power factor correction (pfc) C over voltage, short circuit, lighting, and over temperature protection C ip67 waterproof rating, metal housing C comply with ul8750 & en61347 safety regulation 3 year warranty approvals: single output part number output current range (min. / typ. / max.) output voltage range (min. / max.) efficiency (220vac, full load) over voltage protection (min/typ/max) max. output power ilpa35ju - s290st 2755 / 2900 / 3045 ma 4 / 12 vdc 82% 13 / 15 / 17 vdc 35w ilpa35ju - s245st 2328 / 2450 / 2573 ma 5 / 15 vdc 83% 16 / 18 / 20 vdc 35w ilpa35ju - s210st 1995 / 2100 / 2205 ma 6 / 18 vdc 84% 19 / 21 / 23 vdc 35w ilpa35ju - s175st 1663 / 1750 / 1838 ma 7 / 20 vdc 84% 23 / 25 / 27 vdc 35w ilpa35ju - s140st 1330 / 1400 / 1470 ma 8 / 24 vdc 85% 30 / 32 / 34 vdc 35w ilpa35ju - s105st 998 / 1050 / 1103 ma 11 / 33 vdc 86% 39 / 41 / 43 vdc 35w ilpa35ju - s070st 665 / 700 / 735 ma 17 / 50 vdc 86% 57 / 58 / 59 vdc 35w ilpa35ju - s045st 428 / 450 / 473 ma 26 / 78 vdc 87% 95 / 97 / 99 vdc 35w ilpa35ju - s035st 333 / 350 / 368 ma 33 / 100 vdc 88% 118 / 120 / 122 vdc 35w item - s290st, - s245st, - s210st, - s175st, - s140st, - s105st are class 2 output (usr & cnr). item - s070st is class 2 output (usr), non - class 2 output (cnr) item - s045st, - s035st is non - class 2 output (usr & cnr) electrical characteristics parameter test conditions min. typ. max. unit input voltage operating voltage 90 305 vac input frequency 47 63 hz output power range vin=90 to 264vac 0 35 w input current (low line) io=full load, vin=115vac 0.49 a input current (high line) io=full load, vin=230vac 0.25 a high line inrush current io=full load, 25c, cool start, vin=230vac 20 a power factor correction vin=110vac 92 % efficiency io=full load, vin=230vac 82 88 % no - load power consumption no load, vin=230vac 6 w line regulation io=full load 2 % load regulation vin=230vac 5 % over voltage protection (latch mode. the power unit shall return to normal operation only after the power is turn - on again.) over temperature protection 110 c short circuit protection no damage shall occur when any output operating in a short circuit condition. the power supply shall be self - recovery when the fault condition is removed. output overshoot / undershoot when power on or off 10 % start up time io=full load, vin=110vac 1.7 2 s ripple & noise (peak to peak) measured by 20 mhz bandwidth oscilloscope and the output paralleled a 0.1 uf ceramic capacitor and a 10 uf electrolytic capacitor. 10 % vo
conditions parameter test conditions min. typ. max. unit operating temperature humidity: 10% rh to 100% rh - 35 55 c storage temperature humidity: 5% rh to 100% rh - 40 85 c mtbf (operation temperature at 25c, calculated per mil - hdbk - 217f ) 0.541m hours life time (measured at 110vac, 45c ambient temperature, 80% load for 2900ma output model) 0.087m hours no output power derating from - 35c to 55c approvals and compliance parameter standards emi en55015 ems en61000 - 3 - 2, en61000 - 3 - 3, en61000 - 4 - 2, en61000 - 4 - 3 , en61000 - 4 - 4, , en6 1000 - 4 - 5, en61000 - 4 - 6, en61000 - 4 - 8, en61000 - 4 - 11, en61547 safety ul/c - ul, ce ul8750 compliant to ul1310 class 2, ul1012, ul935, csa - c22.2 no. 0, csa - c22.2 no. 107.1, csa - c22.2 no.250.0, en61347 - 1,en61347 - 2 - 13 waterproof ip67 rating mechanical & technical parameter specification dimension, 172x34.5x42.5mm (6.77x1.36x1.67 inches) net weight 480g approx. notes: 1. for the driver to operate properly, the load voltage must be maintained above the minimum voltage threshold (approx. 33% of the max. output voltage for any given model). 2. if the input voltage is within 90 - 175vac, the output current can be varied from 100% down to 10%. (refer to right figure a ) 3. if the input voltage is within 175 - 305vac, the output current can be varied from 100% down to 20%. (refer to right figure b )
|
