kbj10005 thru kbj1010 glass passivated single-phase bridge rectifier features glass passivated chip junction ideal for printed circuit board plastic material has underwriters laboratory flammability classification 94v-0 reliable low cost construction utilizing molded plastic technique mechanical data case: molded plastic, kbj epoxy: ul 94v-o rate flame retardant terminals: leads solderable per mil-std-202, method 208 guaranteed mounting position: any weight: 0.16ounce, 4.6gram maximum ratings and electrical characteristics ratings at 25 ambient temperature unless otherwise specified. single phase, half wave, 60h z , resistive or inductive load. for capacitive load, derate current by 20%. symbols kbj10005 KBJ1001 kbj1002 kbj1004 kbj1006 kbj1008 kbj1010 units maximum recurrent peak reverse voltage v rrm 50 100 200 400 600 800 1000 volts maximum rms voltage v rms 35 70 140 280 420 560 700 volts maximum dc blocking voltage v dc 50 100 200 400 600 800 1000 volts maximum average forward rectified current at t c =100 peak forward surge current, 8.3ms single half-sine-wave superimposed on rated load (jedec method) maximum forward voltage at 5.0a dc and 25 maximum reverse current at t a =25 at rated dc blocking voltage t a =125 typical junction capacitance (note 1) c j pf typical thermal resistance (note 2) r jc /w operating and storage temperature range t j tstg notes: 1- measured at 1 mh z and applied reverse voltage of 4.0 vdc. 2- thermal resistance from junction to case with device mounted on 75mm x 75mm x 1.6mmcu plate heatsink. uamp dimensions in inches and (millimeters) i r -55 to +150 5.0 500 100 3 1.0 i (av) v f 175 10.0 amp amp volts i fsm kbj http://www.trr-jx.com
ratings and characteristic curves http://www.trr-jx.com kbj10005 thru kbj1010 glass passivated single-phase bridge rectifier
|